To Switch From Plunge Base To Fixed Base Or D-Handle Base - Craftsman 315.175340 Operator's Manual

TO SWITCH FROM PLUNGE BASE TO FIXED BASE
OR D-HANDLE BASE
See Figures 4, 5, and 6.
Follow these steps to switch from the plunge base to the
fixed base or D-handle base.
1. Unplug the router.
,_1 WARNING: Failure to unplug the tool could result
in serious injury due to accidental starting.
2. Place the router on a flat surface.
3. Loosen the locking knob.
4. Depress and hold the spindle lock button.
5. Remove the motor housing from the plunge base.
LOCKING
SPINDLE
LOCK
BUTTON
Fig. 4
6. Place the fixed base or D-handle base on a flat
surface.
7. Loosen the locking arm.
8. Align the notch in the depth adjustment ring with the
indicator point on the base.
9. Place the router motor upside down.
10. Align the spindle lock button with the groove in the
base.
11. Depress and hold the spindle lock button on the
motor.
12. Slide the base onto the motor housing.
13. Turn the depth adjustment ring clockwise until the
spindle lock button slides above the locking arm.
14. Tighten the locking arm.
NOTCH
DEPTH
ADJUSTMENT
RING
LOCKING
ARM
Fig. 5
Fig. 6
10