Table of Contents
Advertisement
Installing the RAID Drivers
Your system may come with a Windows install CD that already includes NVIDIA RAID
drivers. If so, then this section is not relevant.
If that is not the case (or you are trying to install a new version of Windows), then you
will need an NVIDIA RAID driver F6 install floppy. Check to see if one came with your
system. If not, you can create one by downloading the appropriate driver package and
following the steps in this section.
1 Create an F6 install floppy by using the ʺ-xʺ option, then copy all files in ʺ...\IDE\
WinXP\sataraidʺ to a floppy disk. (For Windows 2000, substitute ʺWin2Kʺ in the path.)
2 After you complete the RAID BIOS setup, boot from the Windows CD.
The Windows Setup program starts.
3 Press F6 and wait a few moments for the Windows Setup screen to appear.
Windows Setup
S=Specify Additional Devices
Figure 2.19
4 Specify the NVIDIA drivers.
a Insert the floppy that has the RAID driver, press S, then press Enter.
NVIDIA Corporation
Setup could not determine the type of one or more mass storage devices
installed in your system, or you have chosen to manually specify an adapter.
Currently, Setup will load support for the following mass storage device(s):
<none>
* To specify additional SCSI adapters, CD-ROM drives, or special
disk controllers for use with Windows, including those for
which you have a device support disk from a mass storage device
manufacturer, press S.
* If you do not have any device support disks from a mass storage
device manufacturer, or do not want to specify additional
mass storage devices for use with Windows, press ENTER.
Windows Setup—Specify Devices
ENTER=Continue
F3=Exit
Setting Up Your RAID Configuration
C
2
HAPTER
29
Advertisement
Table of Contents
