Care And Cleaning - Frigidaire PLGFZ397GCA Use & Care Manual

Care&Cleaning
Cleaning the Contoured Cooktop Well Areas, Burner Cap, Burner Head and Burner Drip Pans
(some models)
The contoured well areas, burner cap, burner head and burner drip pans (some models) should be routinely cleaned.
Keeping the burner ports clean will prevent improper ignition and an uneven flame. Refer to the following instructions:
THE COOKTOP IS NOT REMOVABLE. Do not attempt to remove or lift the cooktop.
Use caution when replacing the burner cap so the electrode is not damaged. This may cause a delayed
ignition or prevent the burner from igniting.
To Clean the Recessed & Contoured Areas of the Cooktop - If a spill
occurs on or in the recessed or contoured areas, blot up spill with an
absorbent cloth. Rinse with a clean, damp cloth and wipe dry.
Surface
Burner
Grate
To Remove & Replace the Surface Burner Caps & Surface Burner
Heads - Remove in the following order: (1 st) surface burner grate, (2nd)
surface burner cap, (3rd) surface burner head and (4th) surface burner drip pan
(if equipped).
Reverse the procedure above to replace the surface burner cap, surface burner
head and surface burner drip pans (if equipped). Do not remove any parts
from the cooktop until they have completely cooled and are safe to
handle. Do not operate the surface burners without the surface burner
cap and surface burner head properly in place.
/Orifice i
To Clean the Surface Burner Cap, Surface Burner Head & Surface Holder.
Burner Drip Pan (if equipped) =Use a soap-filled scouring pad or a mild ..................
abrasive cleanser to clean the surface burner caps, surface burner heads and
surface burner drip pans (if equipped). The ports (or slots) around the burner
head must be routinely cleaned. If residue still remains in these ports, use a ,._rod
small-gauge wire or needle to clean the slots or holes. For proper flow of gas
and ignition of the burner--DO NOT ALLOW SPILLS, FOOD, CLEANING
AGENTS ORANY OTHER MATERIAL TO ENTER THE GAS ORIFICE
HOLDER OPENING. ALWAYS keep the surface burner cap and surface
burner head in place whenever a surface burner is in use.
Surface
Burner
Cap
Surface
Burner
Head
Removable
Burner
Drip Pan
(on some models)
29