Frigidaire E23CS75DSSH Use & Care Manual page 8

Removing The Doors
TO DISCONNECT
1 Press outer sleeve
foward connector
2 Pull to remove tube
TO CONNECT
insert tube and push until mark
touches face of connector
To removethe freezerdoor:
1 Detach the multi-wire cable connector located above the top hinge.
Grasp both sides of the connector firmly and pull apart.
2 Trace lightly around the hinge with a pencil.
This makes reinstallation easier.
3 Detach the water tube from the connector located below the freezer
door. The connector releases when you press its outer sleeve inward.
4 Remove the screws from the top hinge and
pull the multi-wire cable through it. Lift the
door off of the bottom hinge.
nge
Assembly
Water
5 Remove the three bottom hinge screws and hinge if necessary.
6 Lay the door on its side to avoid damage to the water tube extending
from the bottom hinge.
To reinstall the freezer door, reverse the above steps. Once both doors
are in place, also replace the top hinge cover (see Page 7).