Grounding Instructions; Surface Unit Flame Size; Proper Surface Burner Adjustments - Frigidaire FGFB33WHSA Owner's Manual

Sealed surface burners porcelain enamel or continuous cleaning oven interior
Table of Contents

Advertisement

Grounding
Instructions
(electric ignition models only)
Avoid fire hazard or electrical shock. Do not use
an adapter plug, an extension cord, or remove grounding
prong
from electrical
power cord. Failure to follow
this warning
can
cause serious injury, fire or death.
This appliance
is equipped
with
a 3-prong
grounding
plug for your
protection
against shock hazard and
should be plugged directly into a properly grounded
receptacle.
DO NOT cut or remove the grounding
prong from this plug.
For personal safety, the range must be properly grounded.
For
maximum
safety,
the power cord
must
be plugged into an
electrical outlet that is correctly polarized and properly grounded.
DO NOT Operate
the range
using a 2-prong
adapter
or an
extension cord. If a 2-prong
wall receptacle is the only available
outlet, it is the personal responsibility of the consumer to have it
replaced with a properly grounded 3-prong wall receptacle installed
by a qualified
electrician.
See the INSTALLATION INSTRUCTIONS packaged with this range
for complete
installation
and grounding
instructions.
Grounding type
wall receptacle
\
\
Do not, under any
/
circumstance, cut,
remove, or bypass
the grounding prong.
f
Power supply cord
with 3-prong
grounding
plug
Surface Unit Flame Size
Never extend the flame
beyond
the
outer
edge of the utensil. A higher
flame simply wastes heat and energy,
and increases your risk of being burned
by the flame.
WRONG
For most cooking, start on the highest control setting and then turn to a lower
one to complete the process. Use the chart below as a guide for determining
proper flame size for various types of cooking. The size and type of utensil used
and the amount of food being cooked will influence the setting needed for
cooking.
For deep fat frying, use a thermometer
and adjust the surface control knob
accordingly.
If the fat is too cool, the food will absorb the fat and be greasy.
If the fat is too hot, the food will brown so quickly that the center will be
undercooked.
Do not attempt to deep fat fry too much food at once as the food
will neither brown nor cook properly.
*Flame Size
High Flame
Medium Flame
Low Flame
Type of Cooking
Start most foods; bring water to a boil; pan broiling
Maintain a slow boil; thicken sauces, gravies; steam
Keep foods cooking; poach; stew
*These settings are based on using medium-weight
aluminum
pans with
lids. Settings may vary when using other types of pans.
Proper Surface Burner
Adjustments
The color of the flame is the key to proper burner adjustment.
A good flame
is clear, blue and hardly visible in a well-lighted
room. Each cone of flame
should be steady and sharply defined. Adjust or clean burner if flame is yellow-
orange. To clean burner, see instructions
under General Cleaning.
5

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents