Advertisement
Care&Cleaning
When lowering the lift-up
range top, grasp the sides with finger-
tips only. Be careful not to pinch fingers.
DO NOT drop or bend the range top
when raising or lowering.
This could
damage the surface.
To Raise the Top for Cleaning
(for
Coil Cooktop models
only)
1.
Grasp the sides and lift from the front. Lift-up rods will support the top in a
raised position. Only lift the top far enough to allow the support rods to snap
into place.
2.
Clean underneath using a clean cloth and hot, soapy water.
3.
To lower the top, gently push back on each rod to release the notched su pport.
Hold the range top and slide the lift rods down into the range frame.
Oven
Light
Changing
the Oven Light (some models)
On some models, the oven light automatically turns on when the door is opened.
Some models have a switch located on the control panel to turn on the light. The
oven light is located at the rear of the oven and is covered with a glass shield held
by a wire holder. The glass shield must be in place whenever the oven is in use.
To replace the oven light:
1.
Turn electrical power off at the main source or unplug the range.
2.
Replace bulb with a new 40 watt appliance bulb.
3.
Turn power back on again at the main source (or plug the range back in).
4.
The clock will then need to be reset. To reset, see Setting Oven Controls
in
this Use & Care Manual.
Be sure the range is unplugged and all parts are COOL before
replacing oven light. Wear a leather-faced glove for protection against possible
broken glass.
To Remove
and Replace
Oven Door
To Remove Oven Door;
1.
Open the door.
2.
Remove screws located on the inside of the oven door near the hinges A (one on each side.)
3.
Close the door to the quarter-open position. Grasp the door firmly on both sides and lift up
and off the hinges.
4.
To clean oven door, follow the instructions provided in the Care & Cleaning
table.
To Replace Oven Door:
1.
Be sure the hinge arms are in the quarter-open position. Be careful if pulling the hinges open
by hand. The hinges may snap back against the oven frame and could pinch fingers.
2.
Hold the door at the sides near the top. Insert the hinge arms into slots at the bottom of the
door.
3.
Hinge arms must go into the range slots evenly. The hinge arms should be inserted into the
bottom comers of the door as far as they can go.
4.
If the door is not in line with the oven frame, remove it and repeat the above steps.
The door is heavy. For safe, temporary storage, lay the door flat with the inside
of the door facing down.
15
Advertisement
