Table of Contents
Advertisement
This
USE & CARE MANUAL
provides
specific
operating
instructions
for your
model.
Use the room air conditioner
only as
instructed
in this USE & CARE MANUAL.
These
instructions
are not meant
to cover
every
possible
condition
and situation
that
may occur.
Common
sense and caution
must be practiced
when
installing,
operating,
and maintaining
any appliance.
The power
supply
cord
with
this air conditioner
contains
a current
detection
device
designed
to reduce
the risk
of fire.
Please refer
to the section
'Operation
of
Current
Device'
for details.
tn the event
that the power
supply
cord
is
damaged,
it cannot
be repaired.
It must
be
replaced
with
a cord
from the product
manufacturer.
Avoid fire hazard or electric shock. Do not
use an extension cord or an adaptor plug. Do
not remove
any prong
from
the power
cord.
,
Prevent Accidents
To reduce the risk of fire, electrical shock, or injury to persons when using your air conditioner,
follow basic precautions,
including the following:
Be sure the electrical service is adequate for the model you have chosen. This information
can be found on the serial plate, which is located on the side of the cabinet and behind the
grille.
If the air conditioner is to be installed in a window, you will probably want to clean both
sides of the glass first, tf the window is a triple-track type with a screen panel included,
remove the screen completely before installation.
Be sure the air conditioner
has been securely and correctly installed according to the
Grounding Prong
ot, under any
_0V_
circumstances, cut,
"
3(}AO/
remove or bypass the
grounding prong.
,
separate installation
instructions
provided with this manual. Save this manual and the
installation instructions
for possible future use in removing or reinstalling this unit.
,
When handling the air conditioner, be careful to avoid cuts from sharp metal fins on front
and rear coils.
ii
ii
Electrical Information
The complete electrical rating of your new room air conditioner
is stated on the serial plate.
Refer to the rating when checking the electrical requirements.
•
Be sure the air conditioner
is properly grounded. To minimize shock and fire hazards,
proper grounding is important. The power cord is equipped with a three-prong
grounding
plug for protection against shock hazards.
Your air conditioner
must be used in a properly grounded wall receptacle. If the wall
receptacle you intend to use is not adequately grounded or protected by a time delay fuse
or circuit breaker, have a qualified electrician install the proper receptacle.
Do not run air conditioner
without outside protective cover in place. This could result in
mechanical damage within the air conditioner.
Do not use an extension
cord or an adapter
plug,
DANGER! Avoid Serious Tnjury or Death
This air conditioner
contains no user-serviceable
parts. Always call an authorized Electrolux servicer for repairs.
Do not insert or place fingers or objects into the air discharge area in the front of the unit.
Do not start or stop the air conditioner
by unplugging the power cord or turning off the power at the electrical box.
Do not cut or damage the power cord.
If the power cord is damaged, it should only be replaced by an authorized Electrolux servicer.
In the event of a malfunction
(sparks, burning smell, etc.), immediately
stop the operation, disconnect the power cord, and call an authorized
Electrolux servicer.
•
Do not operate the air conditioner with wet hands.
Do not pull on the power cord.
•
Do not drink any water that is drained from the air conditioner.
2
©2009
E!ec!ro!ux
Home Products,
:[nc:
A!! r!gh!s
reserved.
Advertisement
Table of Contents
