Advertisement
Drying Procedures
Follow fabric care label instructions_
Place small items in a mesh bag
Fill dryer drum
1/3 to 1/2 full
Follow
the guidelines
below
for preparing
the load for drying
Read the Operating
Instructions
card for operating
},our specific
model
Always
read and follow
fabric
care labels
and laundry
product
labels.
To reduce
the risk of fire, electrical
shock,
or injury
to persons,
read
Important
Safety
Instructions,
pages 2-3, before operating
this dryer.
1,
Prepare
items
for drying.
Dr}, items of similar
fabric, weight
and construction
in the same load.
Separate
dark items from light-colored
items
Separate
items that shed lint from
those that attract
lint. If an item sheds lint, turn it inside out
Be sure buckles, buttons and trim are heatproof
and won't
damage the drum finish.
Close zippers,
fasten hooks and Velcro®-Iike
fasteners_ Tie strings
and sashes to
prevent
snagging
and tangling
If possible,
turn pockets
inside out for even drying
Check for stains which
may not have been removed
in washing_
Dryer heat may
permanently
set some stains_ Repeat stain removal
process before
drying
Place small items in a mesh bag to prevent
tangling
and for easy removal
2.
Check that lint screen
is clean and in place,
3,
Load
the dryer,
The average load will fill the drum 1/3 to 1/2 full_ Items need room to tumble
freely
for even drying
and less wrinkling
Do not overload
dryen
When drying large items, dry only 2 or 3 at a time.
Fill out the load with
small and
medium
sized items.
For delicate
or very small
loads, add 2 lint-free
towels
for better
drying,
less
wrinkling,
and to prevent
grease stains caused by fabric softener
sheets.
Do not overdry
items
Overdrying
can cause wrinkling,
shrinkage,
harshness,
and
a build-up
of static electricity,
which
can produce
more lint
If desired, add a dryer fabric softener
sheet
4,
Close the dryer
door
and set dryer
controls
(some
models),
See Operating
Instructions
card for your specific
model controls.
5.
Turn
cycle selector
clockwise
to the desired
setting,
6.
5tart
the dryer.
,
Push Start Button for 2 seconds or turn the START knob clockwise
to ON, hold for
1-2 seconds and release_
To add or remove items when the dryer is running,
open the door_ The dryer will
always stop when the door is opened
Allow the drum to come to a complete
stop
before
reaching
inside
To restart dryer, close the door then
push the Start Button
for 2 seconds
or turn
the START knob clockwise
to ON, hold for 1-2 seconds
and release_
The dryer will not start if the cycle selector
is in the OFF position
7,
When
the cycle ends,
remove
items
immediately
and hang
or fold.
If load is
removed
before the cycle ends, turn cycle selector
to OFF
Feature5
Place the front bar under
the lip of the lint screen opening
Cycle Signal Control
(some models)
When the Cycle Signal Control is ON, a signal will sound at the end of each cycle and during
the Press Saver setting (some models) The volume is adjustable on some models,
Drum Light (some models)
A drum light will come on w,henever the door is opened to illuminate the dryer drum during
loading and unloading
Closing the door turns off the light
Reversible
Dryer Door
Your dryer is equipped with a reversible door The door can be hinged on the right or left
side_ Refer to the INSTALLATION INSTRUCTIONS for directions on changing the door
Drying Rack (some models)
Use the drying rack to dry items which should not be tumble dried,
1_ Open the dryer door and remove the lint screen_
2,
Insert drying rack into the dryer drum Place the front bar under the lip of the lint screen
opening_
3,
Place items to be dried on top of the rack Weight should not exceed I0 Ibs_Leave space
between items, but do not Jet items hang over the sides or through the grids_ Do not
tumble other items when using the drying rack
4,
Select a timed dry setting best suited for items being dried Use only the Air Fluff (no
heat) temperature
setting for items containing
plastic, foam rubber, rubber-like
materials, feathers or down
B,
When itemsare dry, remove the rack and replace the lint screem If lint screen is not in
place, tumbling items could enter the exhaust system and cause damage to the dryer,
3
Advertisement
