Frigidaire LRA08PZU111 Use & Care Manual page 8

Operating Instructions
(continued)
TIMER: DELAY STOP / START FEATURE
heat
R cool
econ
fan only
temp/timer
Hr
timer MODE V ON-OFF
YOU WILL SEE HOW HUCH TIHE IS CHOSEN:
I heat temp/timer
m cool
econ
_n only Hr
m
timer NODE V ON-OFF A
FIRST
DO THIS:
PRESS
TIMER BUTTON
THEN
DO THIS:
PRESS
UP/DOWN BUTTONS
Note: For Delay Stop, the unit must be in the On position.
Note: For Delay Start, the unit must be in the Off position.
First, Press TIMER button, then adjust timer setting, tap or hold the UP arrow ( A ) or the DOWN arrow ( V ) to change delay
timer at 0.5 hour increments, up to 10 hours, then at 1 hour increments up to 24 hours. The control will count down the time
remaining until start (8, 7.5, 7, etc.). The Delay Start Operation automatically selects cooling with maximum Fan speed (if Cool,
Energy Saver, or Fan Only was the last mode selected). The temperature maintained will be the same as previously set. To change
the set temperature, press "COOL" then Up or Down arrows until the desired temperature is indicated on the display. After 5
seconds, the control will automatically change the display back to the hours remaining until the unit will start/stop. Pressing the
unit On/Off button at any time will cancel the Delay Start/Stop function. The Delay Start/Stop Feature will work until the unit either
starts or stops. Once that happens the above steps have to be repeated again.
CHECK FILTER FEATURE, YOU WILL SEE:
temp/timer
auto ] m
hi m filter med
lo reset
V 0N-0FF A FAN SPEED sleep
temp/timer
auto
hi • fitter med
1o reset
V ON-OFF
A FAN SPEED
Note: This feature is a reminder to clean the Air Filter (See
Care and Cleaning) for more efficient operation. The LED
(light) will illuminate after 250 hours of operation. To reset
after cleaning the filter, press the "Filter Reset" button and
the light will go off.
HEATING FEATURE:
heat temp/timer
F
= cool
econ
fan only
timer MODE V ON-OFF A
jr
DO THIS:
PRESS FILTER
RESET BUTTON
YOU WILL SEE:
temp/timer
cool
econ
fun only
timer MODE V ON-OFF A
/
DO THIS:
PRESS MODE BUTTON,
CHOOSE HEAT
8
Note: This feature can be used with any combination of FAN
Speeds (Low speed only on 115V models), Timer, or Sleep
Modes. When in the "Heat" mode,the fan will run continuously
while heat is needed. The temperature will automatically be
maintained anywhere between 55 °F(13 °C) and 80 °F(27 °C)
(The upper limit of temperature could reach 86°F(30 °C) on some
of the 115V models.). When the room set temperature is satisfied,
the fan will cycle off and on to circulate and sample the room air.
02009 Electrolux Home Products, Inc. All rights reserved.