Using The Power Source - Craftsman NEXTEC 320.30562 Operator's Manual

FueIGauge
The FuelGauge indicates the charge of a battery pack. Insert the battery pack
into the Power Source; the FuelGauge will light up for about 5 seconds as
follows:
• The green LED indicates that the battery is fully charged.
The yellow LED indicates that the battery has used approximately one half of
its charge.
The red LED indicates the battery pack is depleted and needs to be charged.
The FuelGauge will blink in red if the appliance draws more than the rated output
of the port.
USING THE POWER SOURCE
After installing the battery pack,
open the access door and
plug in a 12 V Automotive or
5 V USB powered appliance
(Fig. 3). If the appliance draws
more than the rated output of
the port, the Power Source
will shut off all the outlets to
protect the battery pack and
the FuelGauge will blink red. To
restart the power port, remove
and reinstall the battery pack.
Use only appliances rated
within the output specifications
for the port.
Fig. 3
,_, WARNING: To avoid serious personal injury, always remove the battery
pack from the Power Source when cleaning or performing any maintenance.
WARNING: When servicing, use only identical Craftsman replacement parts.
Use of any other parts may create a hazard or cause product damage. To ensure
safety and reliability, all repairs should be performed by a qualified service
technician at a Sears Service Center.
Avoid using solvents when cleaning plastic parts. Most plastics are susceptible
to damage from various types of commercial solvents and may be damaged by
their use. Use clean cloths to remove dirt, dust, oil, grease, etc.
30562 ManuaLRevised_11-0511 Page 8