Craftsman evolv F1711 Operator's Manual page 3

REMOVING AND INSTALLING
DRAWERS:
1. Fully extend the drawer. Push it
back 1/4".
2. Insert a screwdriver into the slot
in the slide and depress the
stop until it clears the lance.
3. Repeat the procedure on the
other slide. Remove the drawer.
_Slot
Lance
/
TO LOCK TOOL CENTER:
• Insert the slotted end of the Iockbar
through the slot in the top tray and
down into the slot on the panel and in
the base.
• The slot in the locking bar fits over the
knob on the panel.
• Close the cover and lock with a
padlock. (Padlock not included).
TO UNLOCK UNITS:
• Reverse the locking procedure.
PLASTIC BIN INSTALLATION:
• If your chest has plastic bins: Insert
the back of the bin at a slight angle
into the plastic sleeve. Straighten bin
and slide into position. Repeat for
remaining bins.
4,
To reinstall the drawer, pry the
stop far enough out to engage
the lance (3/16" to 1/4") and
push the drawer onto the slides
until the stops pass over the
lances.
TO LOCK CHEST:
• Insert the Iockbar (which stores in the
top tray), tabbed end up, into the slot in
the top tray and down into the slot in
the base. Close the cover and lock
with the key.
TO LOCK ROLL-AWAY:
• Insert the Iockbar into the slot in the
base. Move the Iockbar toward the
unit until the bent end fits into the slot
near the lock. Lock with the key. The
Iockbar for the roll-away is stored in a
slot in the top front corner of the unit.
• For casters, use high quality bearing
grease, (yearly).
• Lubricate the slides, (twice yearly).
• Lubricate lock with graphite, (yearly).
• Periodically the drawer fronts, drawer
trim, and other surfaces should be
cleaned with a mild detergent and
water.
• Auto wax will preserve the storage
unit's luster finish. Apply the wax as
to a car. The wax will also help
protect the unit against scratches.
• Grease and oil can be removed with
most standard cleaning fluids. For
safety, use a nonflammable cleaning
fluid.
5 6