Install Steering Wheel; Check Tires; Install Battery - Craftsman 917.255919 Owner's Manual

Y
STEERING WHEEL CAP
2 - 3/8" DIA, WASHER
EERING WHEEL
,,.,_,---- STEERING WHEEL ADAPTER
FIGURE 3
HOOD
BATTERY
COMPARTMENT
FIGURE 4
LOCKWASHER
GFIILL
NUT
LOCKWASHER
WASHER
HEX
BOLTS
BLACK
(NEGATIVE)
CABLE
3. Install Steering Wheel
NOTE: POSITION FRONT WHEELS FORWARD.
a. Use a 9/16"" wrench to remove hex bolt,
Iockwasher and 2-3/8" diameter washer (shown
full size below) hom steering shaft (Fig 3)
©
b ,. Position steering wheel over steering adaptor.
c, Secure steering wheel to steering shaft using
hex bnlt, tockwasher and 2-3/8" diameter
washer (Fig 3L
d, Snap steering wheel cap in place on steering
wheel,, Steering wheel cap found in bag of partso
4. Check Tires
Reduce tire pressure to 14 PSI in front and 10 PSI in rear
tires, (Tires were overinflated for shipping purposes),
DO NOT SHORT BATTERY TERMINALS,
BEFORE INSTALLING BATTERY, REMOVE
METAL BRACELETS, WRISTWATCH
BANDS, RINGS, ETC.
5o Install Battery
a_ Remove hood - See page 23
b. Remove tape from plastic tray, Make sure drain
tube (Fig. 5) is fastened to drain hole in battery
tray and battery tray is positioned in hole of bat-
tery support.
c , Place battery in plastic tray (Battery terminals to
front of tractor)(Fig= 5),
FIGURE 5
DRAIN TUBE
8