Specification Chart - Craftsman 919.174212 Owner's Manual

AREA HAZARD SAFEGUARDS
Use of unsuitable solvents
Toxic Vapors
Compressed Air
The solvents 1,1,1-Trichlorethane
and Methylene Chloride can
chemically react with aluminum
used in paint spray guns, paint
pumps, etc. and cause an explo-
sion. These solvents can also
react with galvanized compo-
nents and cause corrosion and
weakening of parts.
Compressed air from this unit
may contain poisonous carbon
monoxide.
Certain sprayed materials such
as paints, weed killer, sand,
insecticides, etc., may be harmful
if used in a closed area or if
inhaled.
Compressed air may propel dirt,
metal shavings, etc. and result in
possible injury.
This hazard does not affect your compressor
outfit - but it may affect the equipment used
with the outfit. Read the label or data sheet
for the material you intend to spray. Equip-
ment containing aluminum or galvanized
parts that will come in contact with these sol-
vents, and that can contain pressure, must
not be used with these solvents. You must
either change the material, or use only
stainless steel spray equipment.
Never directly inhale the compressed air pro-
duced by this unit.
Be certain to read labels when spraying
paints or poisons.
Use a mask or respirator whenever there is a
chance that you might inhale anything that
you are spraying. Read all instructions so
that you know that your mask will protect you
from what you are spraying.
Never point any nozzle or sprayer toward a
person or any part of the body.
Always wear safety goggles or glasses when
spraying.
SPECIFICATION CHART
Model No. 919.174212 919.174311 919.174410 919.174320
HP 1 1 1 2
Displacement CFM 8.8 8.8 8.8 9.2
Bore 23/4 " 23/4" 23/4 '' 23/4 ''
Stroke 2" 2" 2" 2"
Voltage-Single Phase 1!0-120 110-120 !10-120 220-240
Minimum Branch Circuit Requirement 20 amp 20 amp 20 amp 15 amp
*Fuse Type "Fusetron" Type T "Fusetron" Type T "Fusetron" Type T "Fusetron" Type T
Amperage at Max. Pressure 18.2 18.2 18.2 9.9
Air Tank Capacity 12 gal. 12 gal. (ASME) !2 gal. (ASME) 20 gal. (ASME)
Approximate Cut-in Pressure 75 psig 75 psig 80 psig 80 psig
Approximate Cut-out Pressure 100 psig 100 psig 100 psig 100 psig
SCFM at 100 psig 5.1 5.1 5.1 5.6
SCFM at 90 psig 5.3 5.3 5.3 6.1
SCFM at 40 psig 6.6 6.6 6.6 Z5
SCFM (Standard Cubic Feet per Minute): Unit of measure of air delivery.
SLM (Standard Liters per Minute): Metric unit of measure of air delivery.
PSIG (Pounds per Square Inch Gauge): Unit of measure of pressure.
kPa (Kilo Pascals): Metric unit of measure of pressure.
*A circuit breaker is acceptable.
5