Download Print this page

Craftsman 358.794600 Operator's Manual page 8

25cc/1.5 cu. in. 2-cycle 200 mph/430 cfm gasoline powered blower/vac

Advertisement

Available languages

Available languages

5.
Insert the elbow tube into the blow-
er outlet. Make sure elbow tube rib
is aligned with the blower outlet
groove.
6. Turn knob clockwise
to secure el-
bow tube.
VACUUM TUBE ASSEMBLY
,_IIWARNING:
Stop engine and be
sure the impeller blades have stopped
turning before opening the vacuum inlet
door or attempting to insert or remove
the vacuum or blower tubes. The rotat-
ing blades can cause serious injury.
1. Insert the tip of a screwdriver
into
the latch area of the vacuum
inlet.
Latch Area
Vacuum Inlet Cover
2.
Gently tilt the handle of the screw-
driver toward the front of the unit to
release the latch while pulling up
on the vacuum
inlet cover with your
other hand.
3.
Hold the vacuum
inlet cover open
until upper vacuum
tube is
installed.
Vacuum
Inlet
Cover
/
4,
Vacuum Inlet
Align the tabs on the inside of the
vacuum
inlet with the slots in the
upper vacuum
tube.
Tab
Slot
B,
Push the upper vacuum tube into
the vacuum inlet. Turn the tube
counterclockwise
until a click is felt
to secure the tube to the blower unit.
6. Align slanted end of lower vacuum
tube as shown. Firmly push lower
vacuum tube into upper vacuum
tube.
S,
Slanted end of
_J_
lower vacuum tube
--
_,--
HOW TO CONVERT
UNIT FROM
VACUUM
USE TO BLOWER
USE
,_IL WARNING:
While blowing debris,
hold the unit with the muffler side fac-
ing away from your body and clothes
(see OPERATING POSITION).
1. Remove the elbow tube and vacu-
um bag by turning the knob counter-
clockwise to loosen the elbow tube.
2. Remove the vacuum
tubes by turn-
ing the tubes clockwise.
3. Close the vacuum
inlet cover and
make sure it is latched closed.
4. Reinstall the blower tubes (see
BLOWER TUBE ASSEMBLY).
VACUUM
BAG SHOULDER
STRAP
ADJUSTMENT
WARNING:
While vacuuming
debris, hold the unit with the muffler
side facing away from your body and
clothes (see OPERATING POSITION).
1. Pass the shoulder strap over your
head and onto your left shoulder
as shown.
2. Extend your right arm toward the
rear of the vacuum
bag.
3. Adjust shoulder
strap until the vac-
uum bag/shoulder
strap seam lies
between
your thumb and index
finger.
-8-

Advertisement

loading