Advertisement
INSTALLING
BITS
See _gure 6.
•
Lock the switch trigger by placing the direction of
rotation selector in center position. See Figure2..
•
Open or close chuck jaws to a point where the
opening is slightly larger than the bit size you intend
to use. Also, raise the front of your drill slightly to
keep the bit from falling out of the chuck jaws.
•
Insert drill bit into chuck the full length of the jaws
as shown in Figure 6.
CHUCKBODY
CHUCKJAWS
_lb WARNING:
Do not insert drill bit into chuck jaws
and tighten as shown in Figure 7. This could cause
drill bit to be thrown from drill resulting in possible
serious personal injury or damage to the chuck.
DRILLBIT
CHUCKCOLLAR
RIGHT
Fig. 6
•
Tighten the chuck jaws on drill bit.
•
To tighten the chuck jaws on drill bit; grasp and
hold the collar of the chuck with one hand, while
rotating the chuck body with your other hand.
Note: Rotate the chuck body in the direction of
the arrow marked LOCK to tighten chuck jaws.
•
Do not use a wrench to tighten or loosen the
chuck jaws.
WRONG
Fig. 7
REMOVING
BITS
See Figure 6.
•
Lock the switch trigger by placing the direction of
rotation selector in center position. See Figure 2.
•
Loosen the chuck jaws from drill bit.
•
To loosen: grasp and hold the collar of the chuck
with one hand, while rotating chuck body with your
other hand.
Note: Rotate chuck body in the direction of the
arrow marked UNLOCK to loosen chuck jaws.
•
Do not use a wrench to tighten or loosen the
chuck jaws.
•
Remove drill bit from chuck jaws.
10
Advertisement
