Craftsman WEEDWACKER 316.790130 Operator's Manual page 7

Fig. 3
TO iNSTALL CUTTING ATTACHMENT SHIELD
_ AUTION" To avoid injury, never operate the
trimmer without the cutting attachment shield
installed. If the trimmer is operated without it in
place, you will VOID the warranty.
1. Place the cutting attachment shield onto the shaft housing
above the clamp assembly (Fig. 4).
2. Push the cutting attachment shield down to the top of the
cutting attachment assembly and then rotate the cutting
attachment shield 180 °. Align the 4 screw holes and fit the
cutting attachment shield securely in the recessed pocket
(Fig. 4).
3. Install the four (4) screws (10-24 x 1/2) with a regular Phillips
screwdriver (Fig. 5). Tighten securely.
Cutting
Attachment
Cutting
Attachment
Shield
Fig. 4
ws
Fig. 5
-7-