Assembly Parts; How To Assemble - Eureka 2940-2969 Series Owner's Manual

Assembly Parts

1 Wand and Crevice Wand. (Pull apart.)
2 Dusting Brush.
Hose.
3
Vacuum Cleaner Body.
4
Electrical Cord.
5
Handle.
6
Self Cleaning Duster.
7
Turbo Tool.
8
Screws located in the accessory package.
9

How To Assemble

CAUTION: Assemble the cleaner before using.
CAUTION: Moving parts. Make sure ON/OFF switch is
in the OFF position before plugging in.
Slide the handle into the
1
grooves at the top of the
vacuum body as shown.
Place the two screws
2
(supplied) into the holes at
back of the unit and tighten
with a screwdriver.
3 Pull the electrical cord
up to the cord retainer
and firmly push down
into retainer. This will
keep the cord out of the
way the next time you
vacuum.
Wind the cord around
4
the two cord hooks
on the back of the
vacuum.
Secure plug to the cord
5
to prevent unwinding.
7
8
4
3
1
2
Store the wands
8
on the side of the
vacuum in front of
the hose.
Store the dusting
9
brush on its
holder.
5
6
6 Place the hose on the back
of the vacuum, wrapping
it up and over the hose
hook as shown.
Secure the bottom of the
7
self cleaning duster to
the hose retainer. Firmly
push the end of the hose
into the top of the self
cleaning duster.
3