Parts List; How To Assemble - Eureka 2940 Series Owner's Manual

●
G
●
H
●
D
●
C
●
A
●
B
●
F
●
D
FIG. 2
●
C
●
G
6
FIG. 4
●
E
●
F
FIG. 1
●
J
●
E
●
●
FIG. 3
●
A
FIG. 5
ENGLISH

PARTS LIST

(FIG. 1)
●
A
Wand and crevice wand (pull apart)
●
B
Dusting brush
●
C
Hose
●
D Vacuum cleaner body
●
E
Electrical cord
●
F
Handle
●
G
Self-cleaning duster
●
H
Turbo tool (some models only)
●
I Screws located in the accessory package

HOW TO ASSEMBLE

CAUTION: Assemble the cleaner before using.
CAUTION: Moving parts. Make sure ON/OFF switch is in the OFF
position before plugging in.
Step 1: Slide the handle
●
D
body as shown (FIG. 2).
Step 2: Place the two screws (supplied) into the holes at back of the unit
and tighten with a screwdriver (FIG. 2).
Step 3: Pull the electrical cord
push down into retainer. This will keep the cord out of the way
the next time you vacuum (FIG. 3).
Step 4: Wind the cord around the two cord hooks
vacuum (FIG. 3).
Step 5: Secure plug to the cord to prevent unwinding (FIG. 3).
Step 6: Place the hose
and over the hose hook as shown (FIG. 4).
Step 7: Secure the bottom of the self cleaning duster
retainer. Firmly push the end of the hose into the top of the self
cleaning duster (FIG. 4).
Step 8: Store the wands
hose (FIG. 5).
Step 9: Store the dusting brush
K
K
●
B
●
F
into the grooves at the top of the vacuum
●
E up to the cord retainer
●
K
●
C
on the back of the vacuum, wrapping it up
●
A
on the side of the vacuum in front of the
●
B
on its holder (FIG. 6).
FIG. 6
●
J and firmly
on the back of the
●
G
to the hose