Attachthe short endof the springto the holein the
latchlocklever.Usethespringpullerto attachthe
long endofthe springto thesquareholein the
tongue.The hookedendofthe pullershouldface
awayfromthetongueas shownin figure2.
Assemble theaxleanddrawbartongue to the
wheelsupport, w iththeopensideof tonguefacing
awayfromthe wheelsupport.Fasten the axleto
the wheelsupportusingfour 1/4"x 1-3/4"hexbolts
and1/4"hexnuts.Tighten.Seefigure4.
LONG END
OF SPRING
/
LATCH LOCK
LEVER
SPRING PULLER
FIGURE 2
1/4" x 1-3/4"
HEX BOLT
/
AXLE
DRAW BAR
TONGUE
1/4" HEX NUT
WHEEL
SUPPORT
FIGURE 4
•
Assemble the hitch bracket to the drawbar tongue
using two 3/8" x 1-1/4" hex bolts, 3/8" lock washers
and 3/8" hex nuts. Tighten.
See figure 3.
• Assemble hitch pin to tongue/hitch
bracket and secure
with 1/8" hair cotter pin. See figure 3.
HITCH
PIN
3/8" x 1-1/4"
HEX BOLT
TONGUE
FIGURE 3
•
Assemble
a spacer tube, a 1" flat washer, a wheel
(valve stem facing out) and another 1" flat washer
onto the axle as shown in figure 5. Insert
a cotter
pin through the axle, spreading
the ends. Repeat
on other end of axle.
NOTE: Use the grease fitting to fill the wheel hub with
automotive
type grease after the wheel is
assembled
onto the axle.
WHEEL
\
FLAT
WASHER
\
SPACER
AXLE
TUBE
'k
\
COTTER PIN
FLAT
WASHER
FIGURE 5