Fasten Door Bracket (One-Piece Door) - Craftsman 139.53662SRT2 Owner's Manual

Please read and comply with the warnings and reinforcement instructions on page 24.
They apply to one-piece doors also.
Header Walt
Header
Bracket
2x4 Support
Door
Bracket
-- Finished Ceiling --
Placement
of Door
Bracket __
_ _---- --
Vertical
Garage Door
Horizontal and vertical
reinforcement is needed for
lightweight garage doors
(fiberglass, aluminum, steel,
door with glass panet, etc)
Nut
5/16"-18
Door
Bracket
®
5/16"
Top of Door
(Inside Garage)
Top Edge
of Door
__ Optional
Placement
For a door with no _ Carriage Bolt
exposed framing or for _ _- 5/16"-18x2-1/2"
the optional instaIlation,
use 5/16"xl-1/2" lag
screws (not supplied)
to fasten
• Center the bracket on the top of the door, in line
with the header bracket as shown. Mark holes.
• Drill 5/16" pilot holes and fasten the door bracket
with hardware supplied.
If the door has no exposed framing, drill 3/16" pilot
holes and fasten the bracket with 5/16"x1-1/2" lag
screws (not supplied) to the top of the door.
The door bracket may be installed on the top
edge of the door if required for your installation.
(Refer to the dotted line optional placement
drawing.) Drill 3/16" pilot holes and substitute
5/16"x1-1/2" lag screws (not supplied) to fasten
the bracket to the door.
Hardware Shown Actual Size
© ©
Nut 5/16"-18 Lock Washer 5/16"
Carriage Bolt
5/16"-18x2-1/2"
25