Advertisement
TO REPLACEHEADLIGHTBULB
• Raisehood.
• Pull bulb holder out of the hole in the
backside of the grill. -
._
:,
• Replace bulb in holder
and push bulb
holder securely back into the hole in the
backside of the grill.
• Close hood.
INTERLOCKS
AND RELAYS
Loose or damaged
wiring may. cause your
tractor to run poody, stop running, or pre-
vent it from starting.
•
• Check wiring. See electrical wiring dia-
gram in the Repair Parts section of this
manual.
TO REPLACE
FUSE
Replace with 30 amp automotive-type
plug-in fuse. The fuse holder is located
behind the dash.
formed by an authodzed engine manufac-
turar's service outlet.
TO REMOVE
HOOD AND GRILL
ASSEMBLY
• Raise hood.
.* Unsnap headlight wire connector.
Stand in front of tractor. Grasp hood at
sides, tilt toward engine and lift off of
tractor.
• To replace, reverse above procedure.
_.\
. Hood
ENGINE
Maintenance, repair, orreplacement of the
emission control devices and systems,
wh'w,hare being done at the customers
expense, may be performed by any non-
road engine repair establishment or indi-
vidual Warranty repairs must be per-
formed by an authorized engine manufao
turer's service outlet.
TO ADJUST THROTTLE CONTROL
CABLE
The throttle control has been preset at the
factory and adjustment should not be nec-
essary. Check adjustment as described
below before loosening cable. If adjust-
ment is necessary, proceed as follows:
• With engine not running, move throttle
control lever to fast position.
• Check that speed control lever is
against stop,screw.
If it is not, loosen
casing clamp screw and pull throttle
cable until lever is against scr__R_.
Tighten clamp screw securely.
Idle Fuel
Adjusting Idle Speed
Needle
Screw
Control
Cable
sto_
Clamp Screw
Choke Control Cable
TO ADJUST
CHOKE
CONTROL
The choke control has been preset at the
factory and adjustment should notbe nec-
essary, check adjustment as described
below before loosening cable. If adjust-
ment is necessary;procaed as follows:
• With engine not running,movechoke
control (located on dash panel) to full
choke position.
• "Remove a_ cleaner cover,.f'dterand car-
tddge plate to expose carburetor choke
(See =AIR FILTER" in the Customer Re-
sponsibilities section of this manual).
• Choke should be closed. If it is not,
•loosen casing clamp screw and move
choke cable until choke is completely
closed. T_jhten casing clamp screw se-
curaly.
• Reassemble air cleaner.
Closed for Full
29
Advertisement
