Advertisement
Available languages
Available languages
10.Pullchokerodto"Closed"position.
ChokeRod
l
J
Closed
.J"
NOTE: For a warm engine, be sure the chore rod is in
the "Open" position.
11. Move engine stop switch to "On" position.
\_ 11.f_
"_'__
12. Grasp handle and pull recoil starter lightly until you
feel some resistance, then pull briskly.
WARNING
When
starting
engine,
pull cord
slowly
until resistance
is
felt and then
pull rapidly
to avoid kickback.
If engine
starts
and fails to continue
to run or if increased
resistance
is felt during
starting
pul! attempts,
squeeze
trigger
on spray
gun.
13. Return recoil starter slowly. DO NOT let rope
"snap back" against starter.
14. When engine starts, slowly move choke rod to
"Open" position as engine warms. If engine
falters, move choke rod to "Closed" position, then
to "Open" position.
WARNING
DO NOT touch
hot surfaces.
Allow
equipment
to coo! before
touching.
The pressure
washer
must be at least 5 feet from
structures
having
combustible
walls
and/or
other
combustible
materials.
Keep at least 3 feet of clearance
on al! sides
of pressure
washer
for adequate
cooling,
maintenance
and servicing.
In the State of California
a spark arrester
is required
by law
(Section
4442 of the California
Public Resources
Code).
Other states may have similar
laws. Federal laws apply on
federal
lands. If you equip the muffler
with a spark attester,
it must be maintained
in effective
working
order.
How to Stop Your Cleaning
System
1.
Let engine idle for two minutes.
2.
Move engine switch to "Off" position.
3.
Squeeze trigger
on spray gun to relieve
trapped
pressure
in hose to avoid injury.
NOTE: A small amount of water will squirt out when
_ressure is released.
WARNING
.
Keep
high pressure
hose connected
to pump
and spray
gun while
system
is pressurized.
Squeeze
trigger
on spray
gun to relieve
trapped
pressure,
every time you stop engine.
Engage
trigger
lock on spray
gun.
Engage trigger
lock
on spray
gun when
not in use.
10
Advertisement
