Trouble Shooting - Numark TT200 Operating Instructions Manual

Problem
Turntable does not turn on.
The sound level is very low.
The sound is on one side only.
The output sound is very distorted.
The Target Light glows
inconsistently, flickers, or doesn't
work at all.
The Output sound exhibits
excessive hum or buzzing.
The turntable skips like crazy.
NOTE:
Static electricity and/or other external interference may cause this unit to malfunction. To reset the unit to its normal
condition, turn the power off and then on again. If the problem continues to persist, refer to the connected component's
troubleshooting guides. If the problem is not resolved after checking these items, contact the nearest authorized Numark
dealer.
Cause?
Disconnected Power Cord?
The Turntable is not connected to a
device with a PHONO preamp.
The Cartridge is not properly wired.
The Stylus is worn out.
The RCA audio cord is
disconnected.
The RCA audio cord is damaged.
The Cartridge is not properly wired.
The Stylus is worn out.
The Target Light Lamp is burning or
burned out.
The Turntable Grounding wires are
not connected.
The Turntable is on an unstable
surface.
The Tone Arm is not balanced
properly.
The Stylus is worn out.
Excessive force is being applied
directly down on the platter.
The record is warped.

TROUBLE SHOOTING

Solution
Connect Power Cord.
Connect the device to a preamp DJ
mixer or an AV receiver that has an
input labeled PHONO, not AUX or
LINE.
Reconnect the wires from the
headshell to the cartridge. See the
"Cartridge Setup" section for more
detail.
Replace the stylus on the cartridge.
Replacement styli are available
from most Numark Retailers.
Properly secure the RCA cable to
the preamp device and the bottom
of the turntable. See the "Cable
Connections" section for more
detail.
If the RCA cord is frequently
connected and disconnected, it
may have become damaged and
needs to be replaced.
Reconnect the wires from the
headshell to the cartridge. See the
"Cartridge Setup" section for more
detail.
Replace the stylus on the cartridge.
Replacement styli are available
from most Numark Retailers.
Replace the entire target light with
a compatible Numark part.
Connect the Turntable Ground
wires to their respective Grounding
Lug on all equipment (mixer, etc.)
Follow the guidelines for installation
in the "Setup & Installation"
Section.
Follow the guidelines for optimum
setup in the "Tone Arm Setup"
Section.
Replace the stylus on the cartridge.
Replacement styli are available
from most Numark Retailers.
Reread the "Operation" section of
this manual.
Buy new records.
PAGE 12