Advertisement
Available languages
Available languages
Cycle
Selection
(Con't)
Drying time varies depending on size and dampness of
load and fabric type. If the load is too small or almost
dry, the sensing bars may not detect enough moisture
to continue the cycle and the cycle may end after a few
minutes. Select a Timed Dry setting to dry such loads.
Room temperature and humidity, type of installation and
electrical voltage or gas pressure can also affect drying
time.
Towels
Select this Auto Dry cycle for towel loads.
Heavy Duty
Select this Auto Dry cycle for sturdy work clothes.
Normal
Select this Auto Dry cycle for cotton items.
Perm Press
Select this Auto Dry cycle for cottons and blends with
a no-iron finish.
Delicates
Select this Auto Dry cycle for knits and delicate items.
Touch Up
Select Touch Up to help remove wrinkles from clean
dry items that may have been left in the dryer, have
been stored in crowded closets or drawers or unpacked
from luggage following a trip. The load will tumble for
15 minutes at low heat.
Timed Dry
To manually select the drying time for any load, turn
the knob to Timed Dry. Drying times from 15 to 90
minutes can be selected by continuing to turn the knob.
Drying time will be displayed.
You will not be able to
select a dryness level.
Timed Dry is recommended
when using theAir Fluff/No Heat setting.
Note: To change cycles, press Cancel.
Cycle
Settings
Appropriate drying Temperature, Dryness Level and
Options will automatically be displayed for each cycle.
The settings can be changed before the cycle is started.
Those adjustments will automatically be remembered
each time that cycle is selected.
If a temperature,
dryness level or option is not recommened for a cycle,
the indicator will not light.
If changes are attempted after the cycle starts, the
lights will blink, the signal will beep and "Err" will be
displayed.
To change a setting after the cycle starts,
press Start/Pause, adjust the setting and press Start/
Pause to resume the cycle. See the "Dryer Settings
Chart" for more details.
Drying Temperature
For best results, follow the fabric care label instructions
on items to be dried. To change the drying temperature,
press Temperature to scroll to the desired heat. To
protect your wardrobe, not all temperatures are available
with every cycle.
Maximim heat is recommended for sturdy fabrics.
High heat is recommended for most cotton fabrics.
Medium
heat is recommended
for wrinkle
free,
permanent press and lightweight fabrics.
Low heat is recommended for delicate fabrics.
Air Full/No
Heat should only be used with a Timed
Dry setting to dry items containing feathers, down,
foam rubber, plastics or rubber-like materials; to freshen
clothing, pillows or blankets; or to dust draperies.
Note: Using Air Fluff/No Heat in any Auto Dry
cycle will result in long drying times and/or
wet loads at the end of the cycle.
Dryness Level
To change the dryness level, press Dryness until the
desired selection is made. Select Normal
for most
loads.
Occasionally a load may seem too damp or over-dried
at the end of the cycle. To increase drying time for
similar loads in the future, select More Dry. For loads
requiring less drying time, select Less Dry.
Select Damp Dry for items you wish to partially dry
before hanging or ironing.
i
Note: To prevent over-drying, not every
/
dryness level is available with every cycle.
J
Options
To select an option, press Options until the indicator for
the desired option flashes, then press Select,
If an
option is not available for a cycle, the indicator will not
light, Follow the same steps to delete an option,
A Signal
will sound
at the end of the cycle and
periodically during Extended Tumble. The signal has
an adjustable volume level or can be turned off.
Select Shrink
Guard
to lower the initial
drying
temperature to protect fabrics from overdrying.
Select Extended
Tumble if the dried load might not
be removed promptly at the end of the cycle. The dry
load will continue tumbling without heat for 30 minutes
to help reduce wrinkling. When the Signal is selected,
a beep will be heard periodically.
The load may be
removed any time during Extended Tumble.
To avoid fire hazard, do not use heat to
dry items containing feathers or down, foam rubber,
plastic, or similarly textured, rubber-like materials. Use
theAir Fluff/No Heat setting only.
PN 134884500A
(0710)
Advertisement
