Cycleselections; Energy Optionselections - Electrolux EIDW5905JB0A Use & Care Manual

Operating Instructions
i ii i ii! iii
iiiill i_ _iii _
i i
i_i_ill i_ _i i I /i__i __ii _ _i
iii_ iiii
iii_i i _ iii ii ii
_i_i_ill i_i!iil ii_i_iii_i _ :i!i_ _
iii_ ii
!i_/_i!iiii _! !ii_ __
CYCLE SELECTIONS
You may find that your highly efficient dishwasher
actually washes longer than your old one. The
hydraulic system and cycles are carefully designed
to use less heat and less water. To assure the
dishes get clean with less use of costly resources
more time is spent spraying water. The pump uses
little energy. The advanced filter design allows
water to be used longer before needing to replace it
and results in a better use of resources.
Cycle durations, wash temperatures and water
usage all vary with the cycle and options selected.
When incoming water or the room is colder the unit
will heat and wash longer to be sure to achieve
critical temperatures.
Your dishwasher also uses a Smart Sensor to
understand how heavily soiled the dish load is and
to adjust the cycle accordingly. This sensor is
calibrated at the end of most cycles - when the unit
is sure to have a small amount of clean water
around the sensor. The sensor will not be
calibrated for the first cycle run after power has
been removed from the dishwasher. To assure you
get clean dishes the unit defaults to the cycle
option that is suited for heavy soils on this first run
after power is restored.
Normal Wash
This cycle is an automated, one-cycle-fits-all
solution that is appropriate for all but very special
loads. Its automatic adjustment and wash limits
are nearly identical to the Auto Wash described
above.
QuickWash
This cycle uses power and water (about 6.1 gallons)
at a higher rate to wash dishes quickly
(approximately 42 to 52 minutes). The cycle is
designed to wash lightly soiled or pre-rinsed dishes
and silverware.
Rinse
This cycle is intended for rinsing off food soils when
you do not intend to run afull cycle until much later.
Rinse uses much less water than you would use
rinsing by hand. Unheated water is used to
dissolve and remove much of the soils and wash
them down the drain before they can dry in place or
spoil.
iii _iI i ii
iiii_ ii i iiii i
ii _ i i
_i_i _ i_i i_i_ii I
i i i
Heavy Wash
This is a hard hitting cycle for pots, pans, casserole
dishes and dinnerware with dried-on or baked-on
soils. Water usage is about 9.2 gallons. Wash time
ranges from approximately 140 to 162 minutes.
Auto Wash
This excellent all around cycle uses the
SmartSensor to determine the amount soils that
were on the dishware. Cycle time and water usage
are then automatically adjusted to assure the soils
are fully and efficently removed. Soils from light to
extreme are accommodated. Light soils will result
in a short cycle, heavy soils in a long cycle. Water
usage varies between 3.1 to 9.1 gallons while cycle
duration varying from 93 to 131 minutes.
ENERGY OPTmON SELECTMONS
Hi-Temp Wash
When the HI-TEMP option is selected, the
dishwasher heats water in the main wash to
approximately 140°F (60°C) and in the final rinse to
150°F (65°C). HI-TEMP ON will be displayed.
This increase in water temperature helps
dishwasher detergent remove food, grease and soil
from dishes more effectively and aids in drying.
The HI-TEMP option can only be used with AUTO,
HEAVY and NORMAL cycles.
When the HI-TEMP option is selected, the LED will
illuminate and remain on until the door is closed.