Craftsman 137.218010 Operator's Manual page 9

ASSEMBLE STAND (FIG. A }
1. Unpack allparts andgroupbytypeandsize.Refer
tothepartslistforcorrect q uantities.
2. Attach onelonguppersupport ( 4)totopofleg(1)
usingonebolt(2)andnut(5).
NOTE: D onottightenboltsuntil s tandis properly
aligned (seestep#8before tightening).
3. Attach otherendof longupper support t otopof
another l egusingoneboltandnut.
4. Attach onelongbottom support ( 3)tocenterofeach
legusing bolt(2)andnut(5). Thiscompletes t he
frontframe section.
5. Assemble r earframe section in exactly thesame
manner.
6. Joinfrontandrearframe assemblies u singtwoshort
upper supports (11)andtwoshortbottom supports
(10),boltsandnuts.
7. Insertfootpad(6)intobottom ofleg. Repeat f or
eachleg.
8. Placestandonlevel s urface andadjustsoal!legs
arecontacting t hefloorandareatsimilar angles to
thefloor. Tighten allbolts.
NOTE: S tandshould notrockafteral!boltsare
tightened.
Fig.A
ASSEMBLE TABLESAWTOSTAND (FIG.A-I)
1. Placeprotective c ardboard o r oldblanket onfloorto
protect t hesawtablesurface.
2. Place thesawupsidedown ontheprotective
material (seeFig.A-I).
3. Position thestandupsidedownonthesawbase.
NOTE: M akesurefrontofstandandfrontofsaware
facing thesamedirection.
4. Lineupthefourholesinsawbaseandstand.
5. Fasten sawtostandusingfourbolts(12),washers
(13)andnuts(14).
NOTE: P lace washer o neachboltbefore inserting
intosawbaseandthrough thesupport.Nutmustbe
immediately against t hebracket ( seeFig.A).
6. Tighten allfournuts.
NOTE: D ONOTOVER TIGHTEN NUTS HOLDING
SAWTOSTAND.THISMAYDAMAGE THESAW
BASE.
7. Carefully s etthesawinitsupright p osition ona
cleanlevel s urface.
[A WARNING 1
tF THE STAND WILL NOT BE USED, DO NOT
OPERATE THE TABLE SAW ON THE FLOOR. THIS
tS A VERY DANGEROUS POSITION.
Fig. A-1
1
3
6