Advertisement
Available languages
Available languages
AFTER EACH USE
Water should not remain in the unit for long periods of
time. Sediments or minerals can deposit on pump
parts and "freeze" pump action. Follow these
procedures after every use:
1.
Flush detergent siphoning tube by placing the filter
into a pail of clean water while running pressure
washer in low pressure mode. Flush for one to two
minutes.
2.
Shut off engine, let it cool, then remove all hoses.
3.
Disconnect spark plug wire from spark plug.
4.
Empty pump of all liquids by pulling recoil handle
about 6 times. This should remove most liquid in
pump.
5.
if storing for more than 30 days see "Long Term
Storage" on next page.
6.
Coil high pressure hose and inspect it for damage.
Cuts in hose or fraying could result in leaks and
loss of pressure. Should any damage be found,
replace hose. DO NOT attempt to repair a
damaged hose. Replace hose with genuine Sears
part.
7.
Disconnect hose from spray gun and high
pressure outlet on pump. Drain water from hose,
gun, and nozzle extension. Use a rag to wipe off
hose.
8.
Reconnect spark plug wire to spark plug.
9.
Store unit in a clean, dry area.
WARNING
WINTER
STORAGE
CAUTtON
• Failure
to do so will permanently
damage
your pump
and render
your
unit inoperable.
• Freeze
damage
is not covered
under warranty.
To protect the unBtfrom freezing temperatures:
1.
Flush detergent siphoning tube by placing filter
into a pail of clean water while running pressure
washer in low pressure mode. Flush for one to two
minutes.
2.
Empty pump of all pumped liquids by pulling recoil
handle about 6 times. This should remove most
liquid in pump.
3.
Use pump saver, available at a local Sears service
center, to treat pump. This minimizes freeze
damage and lubricates pistons and seals.
4.
If pump saver is not available, connect a 3-foot
section of garden hose to water inlet adapter. Pour
RV-antifreeze
(antifreeze without alcohol) into
hose. Pull recoil handle twice. Disconnect 3-foot
hose.
WHEN
STORING
FUEL OR EQUIPMENT
WiTH
FUEL
IN
TANK
Store away
from furnaces,
stoves,
water
heaters,
clothes
dryers
or other
appliances
that have pilot light or other
ignition
source
because
they
can ignite fuel vapors.
WHEN
DRAINING
FUEL
Turn pressure
washer
OFF and let it cool at least 2
minutes
before
removing
fuel cap. Loosen
cap slowly
to
relieve
pressure
in tank.
Drain fuel tank outdoors.
Keep fuel away from sparks,
open
flames,
pilot lights,
heat, and other
ignition
sources.
DO NOT light a cigarette
or smoke.
17
Advertisement
