Craftsman 139.53976SRT Owner's Manual page 25

ONE-PIECE D OORS
Please readandcomply withthewarnings and
reinforcement instructions o ntheprevious page.
Theyapplyto one-piece d oorsalso.
• Center t hedoorbracket o nthetopofthe door, i n
linewiththe header b racket a s shown. M arkeither
theleftandright,or thetopandbottom holes.
• Drill5/16"pilotholesandfasten the bracket w ith
hardware supplied.
If the doorhasnoexposed framing, d rill3/16"pilot
holesandfastenthebracket w ith5/16"x1-1/2" lag
screws (notprovided) tothetopof thedoor.
NOTE: The door bracket may be instafled on the top
edge of the door if required for your installation.
(Refer to the dotted line optional placement drawing.)
Drill 3/16" pilot holes and substitute 5/16"x1-1/2" lag
screws (not provided) to fasten the bracket to the
door.
HARDWARE SHOWN ACTUAL SmZE
Nut 5/16"-18 Lockwasher 5/16"
Carriage Bolt
5/16"-18x2-1/2"
Header Wall
2x4 Support
--Finished Ceiling--
Header
Bracket
Optional
Placement
of Door
Bracket
Door
Bracket
Vertical
Centerline of
Garage Door
Horizontal and vertical
reinforcement is needed for
lightweight garage doors
(fiberglass, aluminum, steel,
door with glass panel, etc.)
(not provided).
÷
Door
For a door with no exposed framing,
or for the optional installation, use
5/16"x1-1/2" lag screws (not provided)
to fasten door bracket.
Lock
Washer
' 5/16"
Top of Door
(Inside Garage
Top Edge
of Door
Optional
Placement
Carriage Bolt
5/16"-18x2-1/2"
25