Advertisement
ASSEMBLY
TOOLS
NEEDED
@
,
,
7/16-inch
wrench
Screwdriver (small)
ATTACHING
ELECTRODE
HOLDER
TO ELECTRODE
CABLE
Grasp
the electrode
holder
and locate the
slotted head, handle
locking screw near the
mid-point
of the insulating handle. Loosen this
screw
approximately
two turns, or until the
handle can be slipped off the electrode holder.
DO NOT REMOVE THIS SCREW COMPLETE-
LY. Slide the handle off electrode holder
and
insert end of electrode cable assembly through
the handle.
The electrode cable is the one with insulation
stripped from one end.
1/4" Hex "L" Wrench
(furnished)
3. Using the sockethead
wrench (supplied) back
out the hex-head
set screw, located
near the
end of electrode
holder until the end of screw
does not protrude
into the wire socket in the end
of holder.
4. Make sure the wire strands on stripped end of
electrode
cable have not been "frayed".
Twist
together
with fingers if necessary.
5. Insert end
of electrode
cable
into electrode
holder and tighten the socket-head
set screw
very firmly
using
the
1/4"
Hex "L" wrench
furnished.
6. Slide the handle back into place on electrode
holder and position it until the hole in handle is
directly' over the head of handle Iock__nng s crew.
Tighten
the
screw
clockwise
(,"_.)
just
enough
to secure
the handle
on e_ectrode
holder.
ATTACHING
THE WORK
CLAMP
TO THE WORK
CABLE
1. Attach the terminal on end of work cable to the
work clamp.
2. Do not use either of the holes in handle ends of
work clamp.
3. Tighten the screw firmly enough to insure good
contact
and prevent
the cable terminal
from
slipping
on the clamp.
Advertisement
