Craftsman 137.212000 Operator's Manual page 4

RECOMMENDED A¢CESSORgES
e Use only accessories recommended for this miter
saw. Follow instructions that accompany accessories.
Use of improper accessories may cause hazards.
÷ The use of any cutting tool except 10 inch saw
blades which meet the requirements under
recommended accessories is prohibited. Do not use
accessories such as shaper cutters or dado sets.
Ferrous metal cutting and the use of abrasive wheels
is prohibited.
Do not attempt to modify this too! or create
accessories not recommended for use with this tool.
Any such alteration or modification is misuse and
could result in a hazardous condition leading to
possible serious injury.
ACCESSORIES
Visit your Sears Hardware Department or see the Sears
Power and Hand Toot Catalog to purchase
recommended accessories for this power tool.
To avoid the risk of personal injury, do not modify this
power tool or use accessories not recommended by
Sears.
Read warnings and conditions on your CARBIDE
TIPPED SAW BLADE. Do not operate the saw without
the proper saw blade guard in place. Carbide is a very
hard but brittle material. Care should be taken while
mounting, using, and storing carbide tipped blades to
prevent accidental damage. Slight shocks, such as
striking the tip while handling, can seriously damage the
blade. Foreign objects in the workpiece, such as wire or
nails, can also cause tips to crack or break off. Before
using, always visually examine the blade and tips for
bent blade, cracks, breakage, missing or loose tips, or
other damage. Do not use if damage is suspected.
Failure to heed safety instructions and warnings can
result in serious bodity injury.
Blade wrench (supplied)
Phillips screwdriver
Slotted screwdriver
Adjustable wrench
Hex Key 2.5 ram.
_',7_t I kL/X'i
Combination square
COMBINATION SQUARE MUST BE TRUE
Draw light
line on board
along this edge. / -"
l
i,I,1
Should be no jap or overlap
when square _sflipped over
in dotted position
hStraight edge or
board 3/4" thick
is edge must be
perfectly straight
UNPACKUNG YOUR M_TER SAW
To avoid injury from unexpected starting or electrical
shock, do not plug the power cord into a source of power
during unpacking and assembly. This cord must remain
unplugged whenever you are working on the saw.
.
Remove the miter saw from the carton.
IMPORTANT: Do not lift the miter saw by the switch
handle or miter table handle, It may cause
misalignment. ALWAYS LIFT THE MACHINE BY
THE BASE HAND HOLDS.
11
Screws
2. Place the saw on a secure stationary work surface,
3. Separate all parts from the packing material. Check
each one with the illustration to make certain all
i{ems are accounted for, before discarding any
packing material.
If any part is missing or damaged, do not attempt to
assemble the miter saw, or plug in the power cord until
the missing or damaged part is correctly replaced. To
avoid electric shock, use only identical replacement parts
when servicing double insulated tools.
Dust Collect
Elbow
Left & Right Miter Table Blade
Extension Wings Handle Wrench Dust Bag
Hold-down
Clamp