Advertisement
Available languages
Available languages
STARTING
YOUR TRAK-CUT
TM
CIRCULAR
SAW
The unit has a sliding on/off
trigger with lock-on switch.
To switch the unit on, slide
the trigger backwards. If you
require the unit to remain
on, squeeze up the lock-on
trigger and release. This will
keep the unit switched on.
To switch off the unit depress
the lock-on trigger and let the
trigger slide forward to the off positon.
STARTING
A CUT
AWARNING:
ALWAYS clamp and support workpiece securely.
ALWAYS maintain proper control of saw. Failure to clamp and support
workpiece and loss of control of saw could result in serious injury.
1. Unplug the saw.
AWARNING:
ALWAYS unplug saw before making any adjustments.
Failure to unplug the saw could result in accidental starting which
can cause serious personal injury.
2. Set-up and clamp your
workpiece and mark your
cut line.
3. Set the Depth-of-Cut.
4. Plug in the saw.
5. Hold saw firmly with both
hands.
6. Position the front of the
saw's base onto the
leading end (edge) of the workpiece that is solidly
supported. Align the center of the cut line indicator
(15) on the front of the base with the cut line.
7. Manually release the blade guard release lever
while holding the finger lift bracket on the rear
of the base as you lower the saw's handle and
blade to the selected depth. MAKE SURE THE
BLADE IS NOT MAKING CONTACT WITH THE
WORKPIECE.
8. With both hands on the handle, squeeze the trigger's molded finger grip
safety release "backward" while squeezing down on the paddle switch to
turn the saw "On". For continuous operation, use the lock-on trigger (19).
13
Advertisement
