Maintenance - Craftsman 917.377523 Owner's Manual

5.0 horsepower 22" rear discharge power propelled rotary lawn mower
Table of Contents

Advertisement

These accessories
were available when this lawn mower was produced.
They are not
shipped with your mower. They are also available at most Sears retail outlets and service
centers. Most Sears stores can also order repair pads for you, when you provide the model
number of your lawn mower.
Some of these accessories
may not apply to your lawn mower.
LAWN MOWER
PERFORMANCE
CLIPPING DEFLECTOR
FOR REAR DISCHARGE
LAWN MOWERS
GRASS CATCHERS
FOR
REAR DISCHARGE
LAWN MOWERS
MULCHER KITS
1
GRASSCATCHERS
FOR
STABILIZER
GAS CANS
SIDE DISCHARGE
LAWN MOWERS
LAWN MOWER
MAINTENANCE
MUFFLERS
AIR FILTERS
SPARK PLUGS
BELTS
BLADES
BLADE ADAPTERS
WHEELS
ENGINE OIL
Read these instructions
and this manual
in
its entirety before you attempt to assemble
or operate
your new lawn mower.
IMPORTANT:
This lawn mower is shipped
WITHOUT
OIL OR GASOLINE
in the
engine.
Your new lawn mower has been as-
sembled at the factory with the exception
of
those parts left unassembled
for shipping
purposes.
To ensure safe and proper
operation
of your lawn mower, all parts and
hardware
you assemble
must be tightened
securely.
Use the correct tools as neces-
sary to ensure proper tightneSS.
All parts
such as nuts, washers,
bolts, etc., neces-
sary to complete
the aSSembly have been
placed in the parts bag.
TO REMOVE
LAWN MOWER
FROM
CARTON
• Remove loose parts included with mower.
• Cut down two end comers of carton and
lay end panel down flat.
• Remove all packing materials except
padding between upper and lower handle
and padding holding operator presence
control bar to upper handle.
• Roll lawn mower out of carton and check
carton thoroughly for additional loose
pads.
HOWTO SET UPYOUR LAWN MOWER
TO UNFOLD HANDLE
IMPORTANT:
Unfold handles carefully so as
not to pinch or damage control cables
• Raise handles until lower handle section
locks into place in mowing position.
• Remove protective padding, raise upper
handle section into place on lower handle
and tighten both handle knobs.
• Remove handle padding holding operator
presence control bar to upper handle.
4

Advertisement

Table of Contents
loading

Table of Contents