Page 1
917.377565 • Safety • Assembly • Operation • Maintenance • EspaSol • Repair Parts CAUTION: Read and follow all Safety Rules and Instructions before operating this equipment Sears, Roebuck and Co., Hoffman Estates, IL 60179 Visit our Craftsman websits: www.sears.com/craftsman...
Page 2
Parts Maintenance Parts Ordering Back Cover LIMITED TWO YEAR WARRANTY ON CRAFTSMAN POWER MOWER For two years from date of purchase, when this Craftsman Lawn Mower is maintained, _ubricated, and tuned up according to the operating and maintenance instructions the owner's...
Wear only solid shoes with good traction • Never cut grass by pulling the mower when mowing. towards you. Mow across the face of • Check fuel tank before starting engine. slopes, never up and down or you Do not fill gas tank indoors, when the might lose your footing.
Page 4
These accassorias were available when this lawn mower was produced. They are not shipped with your mower. They are also available at most Sears retail outlets and service centers. Most Sears stores can also order repair parts for you, when you provide the model number of your lawn mower.
Page 5
TO INSTALL A'f'£ACHMENTS HOW TO SET UP YOUR LAWN MOWER Your lawn mower was shipped ready to be TO UNFOLD HANDLE used as a mulcher. To convert to bagging or IMPORTANT: Unfold handles carefully so as discharging: not to pinch or damage control cables. •...
Page 6
KNOW YOUR LAWN MOWER READ THIS OWNER'S MANUALAND SAFETY RULES BEFORE OPERATING YOUR LAWN MOWER. Compare the illustrations with your lawn mower to familianze yourself with the location of various controls and adil_'tm_n_. _av_ thi_ manu_l for flr_ure refgrence. Thesesymbds may appeeron your lawn moweror in literature suppliedwiff= the product.Leamand underst_d e_re meaning.
Page 7
TO ATTACH GRASS CATCHER The operation of any lawn mower can result in foreign • Close the lift top lid. Lift top lid must objects thrown into the eyes, be closed while operating lawn which can result in severe eye damage. mower.
Page 8
ADD GASOUNE DRIVE CONTROL • Fill fuel tank. Use fresh, clean, regular • Self-propelling is controlled by holding unleaded gasoline with a minimum of 87 the operator presence control bar down to the handle and pushing the drive octane. Do not mix oil with gasoline. control lever forward until it clicks;...
MOWING TIPS MULCHING MOWING'rIPS • Under certain conditions, such as very IMPORTANT: For best performance, keep tall grass, it may be necessary to raise mower housing free of built-up grass and the height of cut to reduce pushing trash. See "Cleaning" in Maintenance section of this manual.
IMPORTANT: Blade bolt is grade 8 heat • Remove any trash or grass cuttings treated. from inside the dust cover, pinion and/ or drive wheel gear teeth. TO SHARPEN BLADE • Put wheels back in place. NOTE: We do not recommend sharpen- •...
Page 13
MUFFLER TO CHANGE ENGINE OIL Inspect and replace corroded muffler as it NOTE: Before tipping lawn mower to could create a fire hazard and/or damage. drain oil, drain fuel tank by running SPARK PLUG engine until fuel tank is empty. Change your spark plug each year to make •...
Page 14
TO ADJUST HANDLE ACAUTION: Before performing service and adjustments: The handle can be mounted in a high or • Release control bar and stop engine. low position. The mounting holes in the • Make sure the blade and all moving bottom of lower handle are off center for parts have completely...
ENGINESPEED Sewn Tubular frame Your engine speed has been factory set. Do not attempt to increase engine speed or it may result in personal injury. If you believe that the engine is running too fast or too slow, take your lawn mower to an authorized service center for repair and adjustment.
Upper Immediately prepare your lawn mower for Operator presence control bar storage at the end of the season or if the unit handle will not be used for 30 days or more, Fold toward ,_"_- LAWNMOWER When lawn mower is to be stored for a period of time, dean if thoroughly, remove all dirt, grease, leaves, etc.
Page 17
CYLINDER cover it to give protection from dust and dirt. • Remove spark plug. • Cover your unit with a suitable protective • Pour on_ ounce (29 ml) of oil through spark cover that does not retain moisture. Do plug hole into cylinder. not use plastic.
TROUBLESHOOTING CHART PROBLEM CAUSE CORRECTION Excessive Wom, bent or loose blade. Replace blade. 13ghten vibration blade bolt. Contact an authorized Bent engine crankshaft. service center. Starterropehard Engine flywheel brake is on Depress control bar to topul when control bar is released. upper handle before pulling starter rope.