To Assemble Grass Catcher; Engine Speed - Craftsman 917.377523 Owner's Manual

TO ASSEMBLE GRASS CATCHER
• Insert leg of tubular frame through front
opening of grass catcher and thread
frame into sewn hem of bag.
NOTE: Keep bag hem gathered on the
straight leg of the tubular frame.
• When frame comes out the other end
of sewn hem, immediately work the
end of frame down inside the bag as
shown in inset.
• Slide sewn hem evenly around the
tubular frame until both ends of frame
are exposed out of the front opening.
• Assemble lower frame to tubular frame
as shown. Be sure handle is outside of
bag and frames are fully seated as
shown in inset.
• Slip vinyl bindings over frame.
NOTE: If vinyl bindings are too stiff, hold
them in warm water for a few minutes, if
bag gets wet, let it dry before using.
• Close the flip lid Flip lid must be
closed while operating lawn mower.
_,CAUTION: Do not run your lawn
mower without clipping deflector or
approved grass catcher in place. Never
attempt to operate the lawn mower with
the rear door removed or propped open.
Sewn h_
Tubular fram_ ,_#
Sewn hem
Flip lid
Lower Frame
(Frames mUe_t
," .." "' " "" s.be fully
Frame
Lower frame handle
ENGINE
ENGINE SPEED
Your engine speed has been factory set. Do
not attempt to increase engine speed or it
may result in personal injury. If you believe
that the engine is running too fast or too slow,
take your lawn mower to an authorized
service center for repair and adjustment.
CARBURETOR
Your carburetor is not adjustable. If your
engine does not operate properly due to
suspected carburetor problems, take you[
lawn mower to an authorized service center
for repair and/or adjustment.
IMPORTANT: Never tamper with the engine
governor, which is factory set for proper
engine speed. Overspeeding the engiqe
above the factory high speed setting can be
dangerous.. If you think the engine-governed
high speed needs adjusting, contact your
nearest authorized service center, which has
proper equipment and experience to make
any necessary adjustments.
15