To Assemble Grass Catcher; Install Starter Rope - Craftsman 917.364250 Owner's Manual

TO ASSEMBLE GRASS CATCHER
1. Put grass catcher frame into grass bag
with rigid part of bag on the bottom.
Make sure the frame handle is outside
of the bag top.
2. Slip vinyl bindings over frame.
NOTE: If vinyl bindings are too stiff, hold
them in warm water for a few minutes. If
bag gets wet, let it dry before using.
Vinyl
binding
Frame
opening
INSTALL STARTER ROPE
(MODELS EQUIPPED WITH ]'-KNOB)
1. Loosen T-knob.
2. Hold control bar against upper handle.
3. Slowly pull engine starter rope out until
rope will slip into loop of rope guide.
4. Tighten T-knob.
Control bar
)er handle
Rope guide T-Knob
rop_
TO INSTALL ATTACHMENTS
Your lawn mower was shipped ready to
be used as a mulcher, To convert mower
to bagging or discharging, see "TO CON-
VERT MOWER" in the Operation section
of this manual.
7