Cleaning And Applying Chemical; To Apply Detergent - Craftsman 580.752410 Operator's Manual

Formaximum rinsing(higher p ressure and
lower flow),forstubborn or hardto reach
surface suchassecond storysurfaces, paint
removal, oilstains,rustremoval o r other
stubborn substances ( tar,gum,grease, w ax,
etc.),selectredMaxProjectPro
TM
nozzle.
To apply detergent, applies project specific
cleaners to help break down stubborn dirt and
grime on a variety of surfaces, select black
ProjectPro
TM
cleaning detergent nozzle.
4. Pull back on collar, insert selected ProjectPro
TM
nozzle and release collar. Tug on ProjectPro
TM
nozzle to make sure it is securely in place.
5. For most effective cleaning, keep ProjectPro
TM
nozzle from 8 to 24 inches away from cleaning
surface. If you get the nozzle too close, you may
damage the cleaning surface.
6. DO NOT get closer than 6 inches when cleaning tires.
Cleaning and Applying Chemical
IMPORTANT: Use chemicals designed specifically
for pressure washers. Household detergents could
damage the pump.
CAUTION
Starting the engine without all the hoses connected and
without the water turned ON wil! damage the pump,
Damage to equipment resulting from failure to follow this
instruction will void warranty,
To apply detergent follow these steps:
1, Review ProjectPro
TM
nozzle use.
2. Prepare detergent solution as required by
manufacturer.
3. Place filter end of detergent siphoning tube into
detergent container.
CAUTION
When inserting the filter into a detergent solution bottle,
route the tube so as to keep it from inadvertently
contacting the hot muffler,
4. Make sure black ProjectPro
TM
cleaning detergent
nozzle is installed.
NOTE: Detergent cannot be applied with the high
pressure nozzles (Yellow, Orange or Red).
5. Make sure garden hose is connected to water
inlet. Check that high pressure hose is connected
to spray gun and pump and start engine.
6. Apply detergent to a dry surface, starting at lower
portion of area to be washed and work upward,
using long, even, overlapping strokes.
7. Allow detergent to soak in between 3-5 minutes
before washing and rinsing. Reapply as needed to
prevent surface from drying. DO NOT allow
detergent to dry on (prevents streaking).
IMPORTANT: You must flush the chemical injection
system after each use by placing the filter into a
bucket of clean water, then run the pressure washer in
low pressure for 1-2 minutes.
13