Advertisement
Reter to Figure 5 (page 6).
MAGAZINE
AND PISTON-RAM
•
Keep magazine and nose clean and free of any dirt, lint or
abrasive particles.
The tip of the ram (Fig. 5, No. 10) can become dented or
rounded over time.
•
Square off the tip of the ram with a clean, fine hand file to
extend the life of the ram and tool. Fastener driving will be
more consistent if the ram tip Is kept clean and square.
REBUILD KITS
Rebuild kits are available as spare parts (see page 7). Tools
shoutd be rebuilt if tool fails to operate propedy after extended
use. See troubleshooting to determine required replacement
parts.
Disconnect tool from air supply before attempting repair
or adjustment.
NOTE: When replacing O-rings or cytinder, lubricate with air
tool oil before assembly.
4
Advertisement
