Table of Contents
Advertisement
ASSEMBLY
HOW TO SET UP YOUR TRACTOR
PREPARE
BATTERY
(See Fig. 2}
CAUTION: Wear eye and face shield.
Wash hands or clothing immediately if
accidentally
in contact with battery acid,
Do not smoke.
Fumes from charged
battery
acid are explosive.
Read the instructions
included with the
battery vent caps. Always wear gloves,
clothing
and goggles
to protect your
hands, skin and eyes.
Your tractor
has a battery charging
system which is
sufficient for normal use. However, periodic charging of the
battery with an automotive charger will extend its life.
o
See instructions packed with vent caps in parts bag.
*
Fill battery with acid. Fill each cell until it reaches the
bottom of the vent wells. Do not oveffitl.
.
Allow battery to stand and settle for at least thirty
minutes.
After standing, check the battery cell acid
level,
tf below the vent wells, add more acid until the
correct level is reached.
While battery is standing (after adding acid) and later, while
battery Jsbeing charged, continue with assembly of tractor.
IMPORTANT:
TO MAXIMIZE
THE LIFE OF YOUR
BATTERY,
1T IS NECESSARY THAT THE BATTERY BE
CHARGED
BEFORE
USE.
FAILURE
TO CHARGE
BATTERY CAN RESULT IN A SHORTENED
BATTERY
LIFE.
o
Charge battery at a rate of 6 amperes for 1 hour. Use
a 12 vott battery charger. Observe all safety precau-
tions required for battery charging.
•
Check the acid level after the battery is charged. If the
acid has fallen below the correct level, add distilled or-
iron free water.
install the vent caps to cover the vent wells. Wash the
top of the battery with water to remove any acid, then
wipe dry.
=
Check battery case for leakage to make sure that no
damage has occurred in handling.
o
Dispose of excess battery acid. Neutralize
acid for
disposal by adding it to two gallons of water in a five
gallon plastic container. Stir with a wooden or plastic
paddle while adding baking soda until the addition of
more soda causes no more foaming.
iNSTALL
SEAT (See Fig, 3)
Adjust seat before tightening adjustment knob.
Remove cardboard packing on seat pan.
o
Place seat on seat pan and assemble shoulder bolt,
Assemble adjustment knob and flat washer loosely.
Do not tighten.
o
Tighten shoulder bolt securely.
o
Lower seat into operating position and sit on seat.
Slide seat until a comfortable position is reached which
allows you to press clutch/brake
pedal all the way
down.
o
Get off seat without moving its adjusted position.
o
Raise seat and tighten adjustment knob securely.
SEAT
SEAT PAN
SHOULDER
BOLT
ADJUSTMENT
KNOB
FIG. 3
FLAT
WASHER
CHECK TIRE PRESSURE
The tires on your tractor were overinflated at the factory for
shipping purposes.
Correct tire pressure is important for
best cutting performance.
Reduce tire pressure to PSi shown in "PRODUCT
SPECIFICATIONS"
on page 3 of this manual
CHECK
BRAKE
SYSTEM
After you learn how to operate your tractor, check to see
that the brake is properly adjusted.
See "TO ADJUST
BRAKE" in the Service and Adjustments
section of this
manual.
o
Follow instructions on how to install baltery.
FiG. 2
8
Hide quick links:
Advertisement
Table of Contents
