Table of Contents
Advertisement
OPERATION
TO ADJUST
GAUGE
WHEELS
(See Fig. 9)
o
Adjust mower to desired cutting height.
•
Lower mower with lift control.
Remove rear retainer
spring and clevis pin which secure each gauge wheel.
o
Lower gauge wheels to ground. Raise gauge wheels
slightly to align holes in bracket and gauge wheel bar
and insert clevis pins. Gauge wheels should be slightly
off the ground.
-
Replace retainer springs into clevis pins.
RETAINER
SPRING
_
CLEVIS
GAUGE
WHEEL BAR
GAUGE
WHEEL
TO OPERATE
ON HILLS
CAUTION:
Do not drive
up or down
hills with slopes greater than 15 ° and
do not drive across any slope.
o
Choose the slowest speed before starting up or down
hifis.
o
Avoid stopping or changing speed on hills.
o
tf slowing is necessary, move throttle control lever to
slower position,
o
If stopping is absolutely necessary, push clutch/brake
pedal quickly to brake position and engage parking
brake.
,
Move motion control lever to neutral (N) position.
iMPORTANT:
THE MOTION CONTROL LEVER DOES
NOT RETURN TO NEUTRAL (N) POSITION WHEN THE
CLUTCH/BRAKE
PEDAL IS DEPRESSED.
o
To restart movement, slowly release parking brake and
clutch/brake pedal.
Slowly move motion control lever to slowest setting.
o
Make all turns slowly.
TO OPERATE
MOWER
(See Figs. 7 and 8)
Your tractor is equipped with an operator presence sens-
ing switch. Any attempt by the operator to leave the seat
with the engine running and the attachment clutch engaged
will shut off the engine.
,
Select desired height of cut.
=
Lower mower with attachment lift control.
•
Start mower blades by engaging attachment
clutch
control.
TO STOP MOWER BLADES - disengage attachment
clutch control.
l&
AUTION:
Do not operate the mower
without
either the entire grass catcher,
on mowers
so equipped,
or the dis-
charge guard in place.
TO TRANSPORT
(See Figs, 7 and 1t)
When pushing or towing your tractor, be sure to disengage
transmission by placing freewheel control in freewheeling
position. Free wheel control is located at the rear drawbar
of tractor.
-
Raise attachment !ifl to highest position with attach-
ment lift control,
Remove retainer spring from freewheel control rod,
°
Push control rod in to disengage transmission
and
reinsert retainer spring into control rod hole now on
back side of the bracket.
•
Do not push or tow tractor at more than two (2) MPH.
•
To reengagetransmission,
reverse above procedure.
NOTE: To protect hood from damage when transporting
you rtractor on a truck or a traiter, be sure hood is closed and
secured to tractor. Use an appropriate means of tying hood
to tractor (rope, cord, etc.),
\
RUNNER
DISCHARGE
GUARD
RGo 10
t3
F_G. 11
Hide quick links:
Advertisement
Table of Contents
