Craftsman WORKBENCH Operator's Manual page 4

- Using four #14-10 x 5/8" blunt tip screws, attach
the stiffener to the center support.
NOTE: Wrench tighten to 80 inilbs. DO NOT OVER
TIGHTEN.
STEP 8: DRAWER AND SLIDE INSTALLAIION.
NOTE: The rear of the frame is referred to as the same side the storage trough
is located. TOP WILL NOT BE SHOWN FOR CLARITY PURPOSES.
• Attach the workbench slides in the top hole of the center posts and sides. Use
eight #14-10 x 5/8" blunt tip screws. (See Fig. 3) _ad (See Fig. next page)
• Repeat this process for each slide in four places as shown.
FRI_
"...._.. / -.--,
Fig. 3
lnse11 the inside slides onto the workbench slides.
li'_d S
,2t_I DE
STEP 9: PARTS TRAY INSTALLATION.
• The p,_'ts tray can be attached on either side and
in two locations.
° Hang each part,_ tray by fitting the hooks into
the slots on each side. Use the top two slot_
with the top hooks on the parts tray.
• See Fig. 4 for one example.
• Pull the inside slides out to ensure they are
locked in for a proper fit.
• Before installing the drawers, lubricate the
chalmels of the drawer slides with grease.
• Install the drawer by inserthag the drawer
slides into the installed slide assemblies.
Make sure that the slides on both sides line
up. Push the drawer until it is fully closed.
The drawer is now securely in place.
• Repeat for other drawer.
l:fig. 4
lqgure sl',ov,_ Step 8 complete without waxlen tcp.
REMO_vqNG AND INSTALLING DRAWERS:
, Fully extend the drawer. Then push it back a fraction of an inch.
• It_sert a screwdriver into the slot in the slide and depress the stop until it
ele_us the lance.
• Repot the procedure for the other slide.
Remove the drawer. ._St_
• To reinstall the drawer, pry the stop far
euough out to engage the lance (3/16"
to 1/4") and push the drawer onto the
slides until the stops pass over the I-ubrieat¢
lances.
• Lubricate the slides with grease or equivalent, (twice yearly).
• Perk_ically the drawer fronts, drawer trim, and other surfaces should be
cleaned with a mild detergent and water.
° Auto wax will preserve the fruit's lmter finiZ Apply the wax as to a ca'.
The wax will also help protect the unit against scratches.
• Grease and oil c_a be reanoved with most standard cleaning fluids. For
safety, use a nonflarmnable cleaning fluid.