Craftsman WORKBENCH Operator's Manual page 2

*SEE EXPLODED VIEW OF ALL COMPONENTS*
VIEW SHOWS LEFT SIDE ORGANIZATIONAL TRAY
ATTACHMENT
STEP 1: REMOVE ALL PARTS FROM THE CARTON.
STEP 2: ASSEMBLE TilE FRAME.
• Using (32) #14-10 x 5/8 blunt tip screws _ssemble the shelf, right side, left
side, front rail and back rail. Finger tighten, then adjust for squareness.
• Rails are assembled with slots showing on the top side.
• Wrench tighten once the unit is squm'e. Tighteaa screws to 80 in/lbs.
NOTE: It is recommended that the shelf be installed with flanges up.
.... ;._ illlLg vd_l ..........
NOTE: USE THE ASSEMBLED FRAME AS A WORK SURFACE WHEN
ATI'ACHING Tim TOP COMPONENTS.
STEP 3: ATTACH STORAGE TROUGH_ TO WOODEN TOP.
! "%N
Attach joint to the inside end of either storage trough.
Slide each storage trough onto the wo(._len top from each end.
Caution: If attachment is too difficult lubricate the bottom of the storage
trough with petroleum jelly or a nomstain equivalent.
STEP 4: ATTACH END CAPS TO STORAGE
TROUGH.
• Slide storage troughs together into the joint.
• Use one #8-32 x _A" screw to attach each end cap.
• The end cap opposite the org_lizational tray location
will be flush to the wooden top.
STEP 5:
STORAGE TROUGH.
• The organizational tray can be attached to
either side of the WORK SURFACE. To
mount to
other side reverse the top.
• Slide the organizational tray into the storage
trough. Use three #10-24 x 1 3/4" carriage
bolts, 114" washers and #10-24 nuts to attach.
ATTACH ORGANIZATIONAL TRAY TO TOP AND
STEP 6: ATTACH ASSEMBLED TOP TO FRAME.
NOTE: Instructions to follow are for centering the wooden top on the flame.
The top may be positioned differently to suit your needs.
• Place the top onto the frame by lining up the four top holes of the pegboard
pattern located on the left side, with the four holes in the organizational tray.
(See Fig. 1)
• Using a tape measure, measure an equal distance from the frame to the edge
of the wooden top, across the fi'ont. This will ensure proper alignment.
• USING A PENCIL, MARK 21-1ESIX HOLE LOCNIlONS INSIDE THE
FRAME AND UNDER THE TOP.
(See Fig. 2 )
Fig. 1 Eg. 2
NOTE: Using adequate help ,carefully tam the top upside down.
• Drill sixholes 114" deep using a 1/8" drill bit.
• Replace the top onto the fi'ame and attach with six #14-10 x 5/8" pointed tip
screws in the top, _uadfour #t4-10 x 5/8" pointed tip screws in the
organizational tray,
CAUTION: Do not over tighten screws in the wooden top.
STEP 7: ATTACH CENTER SUPPORTS AND STIFFENER.
• Using four #14-10 x 5/8" blunt tip screws,
hang the center support from the front and _o_,n- _ IL
back rails.
NOTE: The stiffener may attach to either side
of the center support.