Reversing The Door Swing - KitchenAid KUIS155HLS0 Use & Care Manual

Connecting the drain
Gravity drain system
Connect the drain pump hose (provided with the product)
to your drain in accordance with all state and local codes
and ordinances. If the ice maker is provided with a gravity
drain system, follow these guidelines when installing drain
lines: (This will prevent water from flowing back into the ice
maker storage bin and potentially flowing onto the floor
causing water damage.)
Drain lines must have a minimum of
diameter.
Drain lines must have a 1" drop per 48" [(2.54 cm) drop
per 122 cm)] of run or
30.5 cm)] and must not have low points where water
can settle.
The floor drains must be large enough to
accommodate drainage from all drains.
The ideal installation has a standpipe with a 1 " (3.81
cm) to 2" (5.08 cm) PVC drain reducer installed directly
below the outlet of the drain tube as shown. You must
maintain a 1" (2.54 cm) air gap between the drain pump
hose and the standpipe.
It may be desirable to insulate the drain line thoroughly
up to the drain inlet.
After ensuring that the drain system is adequate, follow
these steps to properly place the ice maker:
1. Plug in ice maker or reconnect power.
2. Re-check the ice maker to be sure that it is level. See
the "Leveling the Ice Maker" section.
3. Push the ice maker into position so that the ice maker
drain tube is positioned over the PVC drain reducer.
SIDE VIEW
"
3 5/8
(9.2 cm)
23"
(58.4 cm)
2" - 1
(5 cm - 3.8 cm)
1. Drain Hose
2. 1" (2.54 cm) Air Gap
3. PVC Drain Reducer
4. Center of drain should be 23" (58.4 cm)
from front of door (with or without the
(1.91 cm) panel on the door).
" (1.6 cm) inside
" drop per 12" [(.635 cm) per
"
1 (2.5 cm)
1/2 "
"
4. If it is required by your local sanitation code, seal the
cabinet to the floor with an approved caulking
compound after all water and electrical connections
have been made.
Drain pump system (on some models)
Connect the drain pump hose (provided with the product)
to your drain in accordance with all state and local codes
and ordinances.

Reversing the Door Swing

TOOLS NEEDED: " wrench,
Phillips screwdriver
-inch Hex Head Hinge Screw
Handle Screw
Endcap Screw
To remove door from hinges:
1. Unplug ice maker or disconnect power.
2. Remove the handle screws and handle (on some
models). Keep the parts together and set them aside.
3. Remove the hinge pin from the top hinge.
4. Remove the door from the hinges and screw the top
hinge pin back into the top hinge.
5. Reverse the door endcaps as follows:
Remove both the screws and endcaps (top and
bottom).
Place the top endcap on the bottom of the opposite
side of the door with the long flat side facing the
door front.
Place the bottom endcap on the top of the opposite
side of the door with the long flat side facing the
door front.
6. Set the door aside.
" wrench, flat putty knife,
Hinge Pin
9