Assembly And Operation - Essick 826 800 Care And Use Manual

Assembly and Operation

1) Unpack humidifier from carton.
2) Remove all packaging materials. Check to see that you have the
following items before discarding packaging:
• Evaporative Wick
• Caster pack
• Lift rod assembly with styrofoam float
Installing Casters:
3) This unit comes equipped with four
casters for added convenience. To
install the casters, lift the chassis off of
the cabinet and place it on a flat, hard
surface where it will not be bumped.
4) Lift out the evaporative wick
frame assembly from the cabinet and
set it aside.
5) To prevent damage to the float and lift rod, untwist the lift rod retainer,
and remove the lift rod assembly from the humidifier cabinet. Do not
attempt to install casters before removing the lift rod assembly.
6) Turn the humidifier cabinet upside down.
7) Install the casters by inserting the caster shaft into the four small holes
positioned roughly 2 inches from each corner of the humidifier cabinet.
Push the casters into the cabinet as far as they will go. Do not force.
Follow this procedure for all four casters. Turn the cabinet right-side up
when done.
Assembling Humidifier:
8) Replace the float assembly and attached lift rod
into the boxed area on the bottom of the inside
of the cabinet. Slip lift rod into retainer ring
and twist to secure. The lift rod should be able
to freely move up and down about 3/8". The
retainer ring should be located between the two
ribs on the lift rod.