Oki LE810DT Setup Manual page 4

1. Open the Top Access Door by swinging it up.
1
2. Open the Front Access Door by pushing down on
the green Dispenser Latch and swinging the door
forward and to the left. This gives access to the print
mechanism on three sides.
Note: The Top Access Door must be open
before the Front Access Door can be opened.
2
3. Open the Print Head Assembly by rotating the green Head
Latch counter clockwise. The head is spring loaded and will
automatically raise to the opened position.
3
4. Pull the Media Supply Guide to the outside of the printer to
give the maximum media width.
4
5. Load the roll onto the Media Holder so that the printing
side of the media faces upwards as it unwinds from the
roll. Push the roll all the way to the inside of the printer,
then push the Media Supply Guide back in until it fits
snugly against the outside of the media roll.
5
6. Route the media under the Media Hold-Down, through the
Media Sensor Assembly, under the Print Head and out
the front of the print mechanism. Push the media all the
way to the inside of the printer. Clear access is provided
to the label path by pulling the top of the Outside Media
Guide down.
Note: Make sure the media is routed through the
Media Sensor Assembly. If it is not, the printer will
react as if there is no media loaded and will refuse
to print.
6
7. Adjust the media sensor to compensate for irregularities
in the media (i.e.: notch, tag hole, gap, perforation or
markings). The proper position will be media-dependent.
To properly adjust the sensor position, loosen the green
Sensor Adjust Knob located on the bottom side of the
Media Transport Assembly and move the sensor in ¼
inch increments (or finer) until the sensor error is cleared.
After the error is cleared, retighten the green Sensor
Adjust Knob.
Outside Media Guide
8
4
7 Sensor Adjust Knob