Setting The Host Mode For The Disk Array Ports - HP XP20000/XP24000 Configuration Manual

2. If host mode option 33 is not enabled, for all LUNs, determine the device number as follows
(once OpenVMS sees the XP disks):
OpenVMS device name ($1$dgaxxx), where xxx = CU with LDEV appended (Then convert the
created number from hex to decimal)
Example
For a LUN with a CU of 2 and an LDEV of 59:
CU with LDEV appended = 259
259 hex = 601 decimal
The example LUN is presented to OpenVMS as $1$dga601.
3. For all LUNs if host mode option 33 is used, the DGA device number is the UUID value for the
LUN.
4. Once all paths are defined, use the SYSMAN utility on each OpenVMS system in the SAN to
discover the array ports and LUNs just added.
For a single system:
$run sys$system:sysman io autoconfigure/LOG
For all systems in an OpenVMS cluster:
$run sys$system:sysman
sysman> set environment/cluster
sysman> io autoconfigure/log
5. Verify the online status of the XP LUNs, and confirm that all expected LUNs are shown online.

Setting the host mode for the disk array ports

After the disk array is installed, you must set the host mode for each host group that is configured on
a disk array port to match the host OS. Set the host mode using LUN Manager in XP Remote Web
Console (shown) or P9000 or XP Command View Advanced Edition Software. For procedures, refer
to the applicable user guide available at http://www.hp.com/support/manuals. If these are not
available, the HP service representative can set the host mode using the SVP.
The required host mode setting for OpenVMS is 05.
When a new host group is added, additional host group modes (options) can be configured. The
storage administrator must verify if an additional host group mode is required for the host group.
12 Installing and configuring OpenVMS for the XP family of disk arrays