Installing And Configuring The Host; Loading The Operating System And Software; Installing And Configuring The Fcsas; Fabric Zoning And Lun Security For Multiple Operating Systems - HP StorageWorks XP10000 - Disk Array Configuration Manual

Figure 3 Direct attach without a SAN example
.
Table 2 Fabric topology settings
Fabric Parameter
ON
ON
OFF
OFF

Installing and configuring the host

This section explains how to install and configure the host and Fibre Channel ServerNet Adapters
(FCSAs) that connect the host to the disk array.

Loading the operating system and software

Follow the manufacturer's instructions to load the operating system and software onto the host. Load
all OS patches and configuration utilities supported by HP and the FCA manufacturer.

Installing and configuring the FCSAs

Install and configure the adapters using the Fibre Channel ServerNet Adapter Installation and Support
Guide, available at the NonStop Technical Library website:
http://h30163.www3.hp.com/ntl/.

Fabric zoning and LUN security for multiple operating systems

You can connect multiple clusters of various operating systems to the same switch using appropriate
switch zoning and array LUN security as follows:
Use Secure Manager for LUN isolation when multiple NonStop systems connect through a shared
array port. Secure Manager provides LUN security by allowing you to restrict which LUNs each
host can access.
Connection Parameter
FC-AL
Point-to-Point
FC-AL
Point-to-Point
XP Disk Array Configuration Guide for NonStop
Provides
Not supported
N-port (SAN fabric port)
NL-port (private arbitrated loop; direct connect without a
SAN)
Not supported
13