Ericsson T18s User Manual page 9

Ericsson mobile phone user's guide
Hide thumbs Also See for T18s:
Table of Contents

Advertisement

8
Preparing Your Phone for Use
an alarm signal (a long beep) sounds and the message
for ten seconds in the display. The signal is repeated several times.
the indicator light on top of the phone starts flashing red.
Note!
The phone turns itself off when the battery can no longer power it satis-
factorily.
Charging the Battery
1.
Make sure that the battery is
attached to the phone.
2.
Connect the charger to the mains.
To indicate charging:
the battery meter in the display pulses continuously.
the indicator on top of the phone shows a steady red light (or green, if the
phone is turned on).
When the battery is fully charged, the battery meter in the display is full and
the indicator on top of the phone shows a steady green light.
Tip!
You can use the phone while the battery is being charged. However, this
increases the charging time.
Battery low
3.
Connect the other end of the
cable to the phone as shown in
the picture. The flash symbol on
the plug must face upwards.
appears

Advertisement

Table of Contents
loading

Table of Contents