Getting Started; Attaching Your Standard Or Swivel Belt Clip - Ericsson T18di User Manual

Getting Started

Complete the following procedures to set up your mobile phone for
the first time:
• Review the document conventions used in this guide by
referring to the "Document Conventions" chapter.
• Attach the belt clip to the phone by referring to the Attaching
the Belt Clip to Your Phone section in this chapter.
• Fully charge and condition your battery by referring to the
Charging Your Battery section in this chapter.
• Turn your phone On by referring to the "Basic Operations"
chapter.

Attaching Your Standard or Swivel Belt Clip

Your Ericsson mobile phone is equipped with either a standard or
swivel belt clip:
Standard Belt Clip
1 Remove the belt clip from the plastic bag.
2 Remove the flexible rubber plug from the top of the clip.
3 While making sure that the screw is going through both the plastic
clip and through the metal support guide, insert the screw into the
opening on the back of the phone.
Getting Started
4 Using a small Philips head screwdriver, turn
the screw clockwise until it is secure as
shown in the following illustration. Do not
over tighten the screw.
5 Inserting the two smaller prongs first,
replace the flexible rubber plug at the top of
the clip.
Swivel Belt Clip
1 Align the screw-in tab between the two
guides on the back of the phone, with the
thicker end on top.
2 Using a screwdriver, attach the tab to the
phone.
3 Place the swivel belt clip on your belt or
waistband.
4 Slide your phone, with tab, into the
swivel belt clip. To remove, press the release mechanism on the top
of the clip and slide the phone up and out of the clip.
Push to
release phone
11