Panasonic SC-AK240 Operating Instructions Manual page 13

1 Press [TUNER, SAND] to select "FM" or "AM".
2
Press [PLAY MODE] to select "MANUAL".
3
Press [I-_1, REW/V] or [IH_4, A/FF] to select the
frequency of the required station.
• "ST" is displayed when a stereo FM broadcast is being
received.
• "TUNED" is displayed when a radio station is tuned.
To tune automatically
Press and hold [I-_P_, REW/v] or [_,-_, A/FF] until the
frequency starts changing rapidly. The unit begins auto
tuning, stopping when it finds a station.
• Auto tuning may be interrupted when there is excessive
interference.
• To cancel auto tuning, press [I-,=t4, REW/v] or [_,-I_1,A/FF]
once again.
Press and hold [PLAY MODE] to display "MONO".
To cancel
Press and hold [PLAY MODE] again until "MONO"
disappear.
• MONO is also cancelled if the frequency is changed.
• Turn off "MQNO" for normal listening.
This unit can display the text data transmitted by the radio
data system (RDS) available in some areas.
If the station you are listening to is transmitting RDS signals,
"RDS" will light up on the display.
Press [DISPLAY] to display:
Press [DISPLAY, -DEMO] on the main unit to display:
Stationnarne _ Program Type _ Frequency display
(PS) (PTY)
,
!
NEWS
AFFAIRS
INFO
SPORT
EDUCATE
DRAMA
CU_URE
SCIENCE
VARIED
POP M
ROCK M
M-O-R- M '}
LIGHT M
CLASSICS
OTHER M
WEATHER
FINANCE
CHILDREN
SOCIAL A
RELIGION
PHONEIN
TRAVEL
LEISURE
JAZZ
COUNTRY
NATIONAL
OLDIES
FOLK M
DOCUMENT
TEST
ALARM
M-O-R- M = "Middle-of-the-Road music"
Note:
RDS displays may not be available if reception is poor,
i_ _ i _ !!!!!!!!!!!!!!!!!!D ¸_
By main unit only
This system can also receive AM broadcasts allocated in
10 kHz steps.
To change the step from 9 kHz to 10 kHz
1 Press and hold [TUNER, BAND].
After a few seconds the display changes to a flashing
display of the current minimum frequency.
2
Continue to hold down [TUNER, BAND].
• When the minimum frequency changes, release the
button. To return to the original step, repeat the above
steps.
• After changing the setting, previously preset frequency
will be cleared.
Up to 15 stations each can be set in the FM and AM bands.
Preparation
Press [TUNER, BAND] to select "FM" or "AM".
1 Tune to the frequency where pre-setting is to begin.
2 Press and hold [PROGRAM] to start presetting.
-I F I'7
The tuner presets all the stations it can receive into the
channels in ascending order. When finished, the last station
memorized is tuned in.
1 Press [PLAY MODE] to select "MANUAL".
2
Press [I-,_P_,REW/V] or [_,-s,4,A/FF] to tune to the
required station.
3
Press [PROGRAM].
4 Press the numeric buttons to select a channel.
For channels 10 to 15 press [>10], then the two digits.
The station occupying a channel is erased if another
station is preset in that channel.
Press the numeric buttons to select the channel.
H /,-2
OR
1 Press [PLAY MODE] to select "PRESET".
2
Press [1_-_, REW/V] or [_,-_1, A/FF] to select the
channel.
o
cc