Panasonic SC-AK240 Operating Instructions Manual page 14

iii ii ii ii i ii ii ii ii iii ii i
SLEEP = CLOCK/TiMER
- -@PLAY/REC
= I_l, REW/V,
_,IN,A/FF
-PRESET EQ
This is a 24-hour clock.
Press [CLOCK/TIMER] to select "CLOCK",
Each time you press the button:
E CLOCK --* QPLAY _ ©REC 1
Original display ÷--
2 (_)
Press [I-,_, REW/V] or [_,-_,,4, V/FF] to set the time,
3
Press [CLOCKJTIMER] to finish setting the time.
Displaying the clock
Press [CLOCK/TIMER] once when the unit is on or in standby
mode.
The time is displayed for a few seconds.
Note:
Reset the clock regularly to maintain accuracy.
You can set the timer to come on at a certain time to wake
you up (play timer) or to record from the radio or music port
source (record timer).
Play timer and record timer cannot be used together.
Turn the unit on and set the dock.
Play timer Prepare the music source you want to listen to;
cassette (DECK 2 has the priority), disc number
(1_5), radio or music port source, and set the
volume,
Record Check the cassette's erasure prevention tabs
timer (m_page 12), insert the cassette in DECK 2 and
tune to the radio station ("_ page 13) or select the
music port source (_ page 16).
1 Press [CLOCK/TIMER] to select the timer function.
Each time you press the button:
E CLOCK --* @PLAY --* ©REC 3
Original display ._--
@PLAY : to set the play timer
©REC : to set the record timer
(Proceed to the next step _)
2
Press
[l_P_,
REW/v] or [_,_-I, A/FF] to set the
starting time.
Play timer indicator
Start time
Record timer indicator
3
Press [CLOCK/TllVIER] to confirm.
4 Repeat steps 2 to 3 to set the finishing time,
F
Finish time
To activate the timer
5 Press and hold [-(bPLAY/REC] to turn on your desired
timer,
E ©PLAY _ @REC q
-- no display (off)__.---------J
6 Press [q to turn off the unit.
The unit must be off for the timers to operate.
change the Repeat steps 1 to 4 and 6 ("_ see above).
settings
change the 1) Press and hold [-@PLAY/REC] to clear the
source or timer indicator from the display.
volume 2) Make changes to the source or volume.
3) Do steps
5 to 6
(_ see above).
check the Press [CLOCK/TIMER] repeatedly to select
settings @PLAYor @REC.
cancel Press and hold [-@PLAY/REC] to clear the
timer indicators from the display.
if you use the unit after the timers are set
After using, check that the correct tape/disc are loaded
before turning the unit off.
$
©
cc